MF10CCN/NOPB ,Universal Monolithic Dual Switched Capacitor Filter 20-PDIP 0 to 70Electrical Characteristics+−V = +5.00V and V =−5.00V unless otherwise specified. Boldface limits ap ..
MF10CCWM ,Universal Monolithic Dual Switched Capacitor FilterMF10 Universal Monolithic Dual Switched Capacitor FilterMay 2001MF10Universal Monolithic Dual Switc ..
MF10CJ ,Kual Universal Switched Capacitor FilterELECTRICAL CHARACTERISTICS (Internal Op Amps)
(Vs = t5V, TA = +25°C)
l.
PARAMETER ' , CONDITIONS ..
MF10CN ,Kual Universal Switched Capacitor FilterGeneral Description
The MF10 is a dual 2nd order, switched capacitor, state
variable filter, Ea ..
MF10CWP ,Kual Universal Switched Capacitor Filter19-1067: Rev l. 7/96
MF1151V-2 , FOR AMPS MOBILE TELEPHONE, Tx
MIC5253-3.3BC5 , 100mA Low Noise μCap Teeny™ LDO
MIC5253-3.3YC5 , 100mA Low Noise μCap Teeny™ LDO
MIC5253-3.3YC5 , 100mA Low Noise μCap Teeny™ LDO
MIC5254-SJYMM , Dual 150mA μCap LDO with Error Flag Outputs
MIC5255-2.5YD5 , 150mA Low Noise Cap CMOS LDO
MIC5255-2.6BM5 , 150mA Low Noise UCap CMOS LDO
MF10CCN/NOPB
Universal Monolithic Dual Switched Capacitor Filter 20-SOIC 0 to 70
MF10-N
www.ti.com SNOS547C–JUNE 1999–REVISED APRIL 2013
MF10-N Universal Monolithic Dual Switched Capacitor Filter
Checkfor Samples: MF10-N
1FEATURES DESCRIPTIONThe MF10-N consistsof2 independent and extremely
• Easyto Use easy to use, general purpose CMOS active filter
• Clockto Center Frequency Ratio Accuracy building blocks. Each block, together with an external
±0.6% clock and3to4 resistors, can produce various 2nd
Filter Cutoff Frequency Stability Directly order functions. Each building block has3 output
pins. Oneof the outputs canbe configuredto perform
Dependent on External Clock Qualityeither an allpass, highpassora notch function; the
• Low Sensitivityto External Component remaining 2 output pins perform lowpass and
Variation bandpass functions. The center frequency of the
• Separate Highpass (or Notchor Allpass), lowpass and bandpass 2nd order functions can be
Bandpass, Lowpass Outputs either directly dependent on the clock frequency,or
they can depend on both clock frequency and
• fO×Q Range upto 200 kHz external resistor ratios. The center frequencyof the
• Operation upto 30 kHz notch and allpass functionsis directly dependent on
• 20-pin 0.3″ Wide PDIP Package the clock frequency, while the highpass center
frequency depends on both resistor ratio and clock.
• 20-pin Surface Mount (SOIC) Wide-Body to 4th order functions can be performed by
Package cascading the two 2nd order building blocksof the
MF10-N; higher than 4th order functions can be
obtainedby cascading MF10-N packages. Anyof the
classical filter configurations (such as Butterworth,
Bessel, Cauer and Chebyshev) canbe formed.
For pin-compatible device with improved performance
referto LMF100 datasheet.
