MC10H158L ,Quad 2-Input MultiplexerELECTRICAL CHARACTERISTICS (V = –5.2 V ±5%)EE0° 25° 75°Characteristic Symbol Min Max Min Max Min Ma ..
MC10H158M ,Quad 2-Input Multiplexer (Non-Inverting)Prepared byCleon PettyAPPLICATION NOTETodd PearsonECL Applications EngineeringThis application note ..
MC10H158M ,Quad 2-Input Multiplexer (Non-Inverting)
MC10H158M ,Quad 2-Input Multiplexer (Non-Inverting)** * ** ** * **The High Speed Solution for theCMOS/TTL Designer
MC10H158MEL ,Quad 2-Input Multiplexer (Non-Inverting)AND8090/DAC Characteristics of ECLDevices
MC10H158ML1 ,Quad 2-Input MultiplexerMAXIMUM RATINGSCASE 775–02Characteristic Symbol Rating UnitPower Supply (V = 0) V –8.0 to 0 VdcCC E ..
MC34675AEPR2 , 28V-Input-Voltage Single-Cell Li-Ion Battery Charger with 10mA Regulator
MC34675AEPR2 , 28V-Input-Voltage Single-Cell Li-Ion Battery Charger with 10mA Regulator
MC3476P1 ,LOW COST PROGRAMMABLE OPERATIONAL AMPLIFIERfeatures low power consumption and high inputimpedance. In addition, the quiescent currents within ..
MC3479P ,Stepper Motor Driver
MC3479P ,Stepper Motor Driver
MC3479PG , Stepper Motor Driver
MC10H158L-MC10H158ML1-MC10H158MR1
Quad 2-Input Multiplexer
SEMICONDUCTOR TECHNICAL DATA "
The MC10H158 is a quad two channel multiplexer with common input select.
A “high” level select enables input D00, D10, D20 and D30 and a “low” level
select enables input D01, D11, D21 and D31. This MECL 10H part is a
functional/pinout duplication of the standard MECL 10K family part, with 100%
improvement in propagation delay and no increase in power–supply current. Propagation Delay, 1.5 ns Typical Power Dissipation, 197 mW Typical Improved Noise Margin 150 mV (Over Operating Voltage and
Temperature Range) Voltage Compensated MECL 10K–Compatible
MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS (VEE = –5.2 V ±5%)
AC PARAMETERS
NOTE:Each MECL 10H series circuit has been designed to meet the dc specifications shown in the test table,
after thermal equilibrium has been established. The circuit is in a test socket or mounted on a printed circuit
board and transverse air flow greater than 500 Iinear fpm is maintained. Outputs are terminated through
a 50–ohm resistor to –2.0 volts.
DIP
PIN ASSIGNMENTD11
D10
D01
D00
VEE
VCC
D20
D21
D30
D31
SELECT
TRUTH TABLEPin assignment is for Dual–in–Line Package.
For PLCC pin assignment, see the Pin Conversion
Tables on page 6–11 of the Motorola MECL Data
Book (DL122/D).
