MC10H130P ,Dual LatchMAXIMUM RATINGSPLCCCASE 775–02Characteristic Symbol Rating UnitPower Supply (V = 0) V –8.0 to 0 Vdc ..
MC10H131 ,Dual Type D Master-Slave Flip-FlopAN1672/DThe ECL Translator GuidePECL • LVPECL • NECL • TTL •LVTTL/LVCMOS • CMOS
MC10H131FN ,Dual D Type Master-Slave Flip-FlopLOGIC DIAGRAMInput Voltage (V = 0) V 0 to V VdcCC I EES1 5Output Current — Continuous I 50 mAout— ..
MC10H131FNR2 ,Dual Type D Master-Slave Flip-FlopELECTRICAL CHARACTERISTICS (V = –5.2 V ±5%) (See Note 1.)EE0° 25° 75°Symbol Characteristic Min Max ..
MC10H131FNR2 ,Dual Type D Master-Slave Flip-Flopfeatures of an ECL device make itrequirement stems only from the speed performance aspectideal for ..
MC10H131FNR2 ,Dual Type D Master-Slave Flip-Flop
MC34261P ,POWER FACTOR CONTROLLERSOrder this document by MC34261/D* **The MC34261/MC33261 are active power factor controllers specif ..
MC34262 ,POWER FACTOR CONTROLLERSELECTRICAL CHARACTERISTICS (V = 12 V (Note 2), for typical values T = 25°C, for min/max values T i ..
MC34262D ,POWER FACTOR CONTROLLERSThermal CharacteristicsP Suffix, Plastic Package, Case 626Maximum Power Dissipation @ T = 70°C P 80 ..
MC34262DR2 ,Power Factor ControllerELECTRICAL CHARACTERISTICS (V = 12 V (Note 2), for typical values T = 25°C, for min/max values T i ..
MC34262DR2 ,Power Factor Controllerfeatures consisting of an overvoltagecomparator to eliminate runaway output voltage due to load rem ..
MC34262P ,POWER FACTOR CONTROLLERSThermal CharacteristicsP Suffix, Plastic Package, Case 626Maximum Power Dissipation @ T = 70°C P 80 ..
MC10H130FN-MC10H130L-MC10H130P
Dual Latch
SEMICONDUCTOR TECHNICAL DATA-
The MC10H130 is a MECL 10H part which is a functional/pinout duplication
of the standard MECL 10K family part, with 100% improvement in clock speed
and propagation delay and no increase in power–supply current. Propagation Delay, 1.0 ns Typical Power Dissipation, 155 mW Typical Improved Noise Margin 150 mV (Over Operating Voltage and
Temperature Range) Voltage Compensated MECL 10K–Compatible
MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS (VEE = –5.2 V ±5%) (See Note)
AC PARAMETERS
NOTE:Each MECL 10H series circuit has been designed to meet the dc specifications shown in the test table,
after thermal equilibrium has been established. The circuit is in a test socket or mounted on a printed circuit
board and transverse air flow greater than 500 Iinear fpm is maintained. Outputs are terminated through
a 50–ohm resistor to –2.0 volts.
DIP
PIN ASSIGNMENTVCC1
CE1
VEE
VCC2
CE2
Pin assignment is for Dual–in–Line Package.
For PLCC pin assignment, see the Pin Conversion
