MC10H102ML1 ,Quad 2-Input NOR GateMAXIMUM RATINGSPLCCCASE 775–02Characteristic Symbol Rating UnitPower Supply (V = 0) V –8.0 to 0 Vdc ..
MC10H102PG , Quad 2−Input NOR Gate
MC10H103 ,Quad 2-Input OR GatePrepared by: Paul ShockmanON SemiconductorAPPLICATION NOTEObjectiveGeneral BackgroundThis applicati ..
MC10H103FN ,Quad 2-Input OR GateMAXIMUM RATINGSPLCCCASE 775–02Characteristic Symbol Rating UnitPower Supply (V = 0) V –8.0 to 0 Vdc ..
MC10H103FNR2 ,Quad 2-Input OR Gate2AN1406/Dreduced while maintaining acceptable manufacturing design. After all the inclusion of ECL ..
MC10H103FNR2 ,Quad 2-Input OR Gate
MC34074 ,Single Supply 3V to 44V, Quad Op Amp
MC34074AD ,Single Supply 3V to 44V, Low Input Offset Voltage, Quad Op AmpELECTRICAL CHARACTERISTICS (V = +15 V, V = –15 V, R = connected to ground, unless otherwise noted. ..
MC34074AD ,Single Supply 3V to 44V, Low Input Offset Voltage, Quad Op AmpOrder this document by MC34071/D " ** ** **"** ** *!#HIGH BANDWIDTH** ** *SINGLE SUPPLYQuality bip ..
MC34074AD ,Single Supply 3V to 44V, Low Input Offset Voltage, Quad Op AmpFeatures SOIC−14D SUFFIX14• Wide Bandwidth: 4.5 MHzCASE 751A1• High Slew Rate: 13 V/s• Fast Settli ..
MC34074AD ,Single Supply 3V to 44V, Low Input Offset Voltage, Quad Op Amphttp://onsemi.com2MC34071,2,4,A MC33071,2,4,A
MC34074ADG , Single Supply 3.0 V to 44 V Operational Amplifiers
MC10H102L-MC10H102ML1
Quad 2-Input NOR Gate
SEMICONDUCTOR TECHNICAL DATA -
The MC10H102 is a quad 2–input NOR gate. The MC10H102 provides one
gate with OR/NOR outputs. This MECL 10H part is a functional/pinout
duplication of the standard MECL 10K family part, with 100% improvement in
propagation delay, and no increases in power– supply current. Propagation Delay, 1.0 ns Typical Power Dissipation 25 mW/Gate (same as MECL 10K) Improved Noise Margin 150 mV (Over Operating Voltage and
Temperature Range) Voltage Compensated MECL 10K–Compatible
MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS (VEE = –5.2 V ±5%) (See Note)
AC PARAMETERS
NOTE:Each MECL 10H series circuit has been designed to meet the dc specifications shown in the test table,
after thermal equilibrium has been established. The circuit is in a test socket or mounted on a printed circuit
board and transverse air flow greater than 500 Iinear fpm is maintained. Outputs are terminated through
a 50–ohm resistor to –2.0 volts.
DIP
PIN ASSIGNMENTVCC1
AOUT
BOUT
AIN
AIN
BIN
BIN
VEE
VCC2
DOUT
COUT
DIN
DIN
CIN
CIN
DOUT
Pin assignment is for Dual–in–Line Package.
