MC10H100P ,Quad 2-Input NOR Gate With Strobe**SEMICONDUCTOR TECHNICAL DATA* * ** **The MC10H100 is a quad NOR gate. Each gate has 3 inputs, tw ..
MC10H101 ,Quad OR/NOR Gatehttp://onsemi.com2MC10H101PACKAGE DIMENSIONSPLCC–20FN SUFFIXPLASTIC PLCC PACKAGECASE 775–02ISSUE CM ..
MC10H101FNR2 ,Quad OR/NOR Gate
MC10H101FNR2 ,Quad OR/NOR Gate
MC10H101M ,Quad OR/NOR Gatefeatures of an ECL device make itrequirement stems only from the speed performance aspectideal for ..
MC10H101MEL ,Quad OR/NOR Gate2AN1406/Dreduced while maintaining acceptable manufacturing design. After all the inclusion of ECL ..
MC34071D ,Single Supply 3V to 44V, Single Op AmpMAXIMUM RATINGSRating Symbol Value UnitSupply Voltage (from V to V ) V +44 VEE CC SInput Differenti ..
MC34071DR2 ,Single Supply 3V to 44V, Single Op AmpELECTRICAL CHARACTERISTICS (V = +15 V, V = −15 V, R = connected to ground. T = +25°C, unless otherw ..
MC34071DR2 ,Single Supply 3V to 44V, Single Op AmpMC34071,2,4,AMC33071,2,4,ASingle Supply 3.0 V to 44 VOperational AmplifiersQuality bipolar fabricat ..
MC34071DR2 ,Single Supply 3V to 44V, Single Op Amphttp://onsemi.commonolithic operational amplifiers. This series of operationalamplifiers offer 4.5 ..
MC34071DR2 ,Single Supply 3V to 44V, Single Op AmpELECTRICAL CHARACTERISTICS (V = +15 V, V = −15 V, R = connected to ground. T = +25°C, unless otherw ..
MC34071DR2G , Single Supply 3.0 V to 44 V Operational Amplifiers
MC10H100L-MC10H100P
Quad 2-Input NOR Gate With Strobe
SEMICONDUCTOR TECHNICAL DATA --
The MC10H100 is a quad NOR gate. Each gate has 3 inputs, two of which
are independent and one of which is tied common to all four gates. Propagation Delay, 1.0 ns Typical 25 mW Typ/Gate (No Load) Improved Noise Margin 150 mV (Over Operating Voltage and
Temperature Range) Voltage Compensated MECL 10K–Compatible
MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS (VEE = –5.2 V ±5%) (See Note)
AC PARAMETERS
NOTE:Each MECL 10H series circuit has been designed to meet the dc specifications shown in the test table,
after thermal equilibrium has been established. The circuit is in a test socket or mounted on a printed
circuit board and transverse air flow greater than 500 Ifpm is maintained. Outputs are terminated through
a 50–ohm resistor to –2.0 volts.
DIP
PIN ASSIGNMENTVCC1
AOUT
BOUT
AIN
AIN
BIN
BIN
VEE
VCC2
DOUT
COUT
DIN
DIN
CIN
CIN
COMMON
INPUT
(A, B, C, D)
Pin assignment is for Dual–in–Line Package.
For PLCC pin assignment, see the Pin Conversion
