MAX6012BEUR-T ,Precision / Low-Power / Low-Dropout /ELECTRICAL CHARACTERISTICS—MAX6012(V = +5V, I = 0, T = T to T , unless otherwise noted. Typical val ..
MAX6018AEUR21+T ,Precision, Micropower, 1.8V Supply, Low-Dropout, SOT23 Voltage ReferenceApplicationsMAX6018BEUR12+T -40°C to +85°C 3 SOT23-3 FZJI● Two-Cell, Battery-Operated SystemsMAX601 ..
MAX6018AEUR21-T ,Precision, micropower, 1.8 V supply, low-dropout, SOT 23 voltage referenceApplicationsPIN- TOPPART TEMP RANGEPACKAGE MARKTwo-Cell, Battery-Operated SystemsMAX6018AEUR12-T -4 ..
MAX6018BEUR18-T ,Precision, Micropower, 1.8V Supply, Low-Dropout, SOT23 Voltage ReferenceApplicationsPIN- TOPPART TEMP RANGEPACKAGE MARKTwo-Cell, Battery-Operated SystemsMAX6018AEUR12-T -4 ..
MAX6021AEUR-T ,Precision / Low-Power / Low-Dropout /FeaturesThe MAX6012/MAX6021/MAX6025/MAX6030/MAX6041/' 0.2% max Initial AccuracyMAX6045/MAX6050 prec ..
MAX6021BEUR-T ,Precision / Low-Power / Low-Dropout /applications.Their low dropout voltage and supply-independent,MAX6021BEUR-T -40°C to +85°C 3 SOT23- ..
MAZ8330 ,Small-signal deviceAbsolute Maximum Ratings T = 25°CaMarking SymbolParameter Symbol Rating UnitRefer to the list of t ..
MAZ8330-H ,Silicon planar typeZener DiodesMAZ8000 SeriesSilicon planar typeUnit : mmFor stabilization of power supplyKA
MAZ8330-M ,Silicon planar typeElectrical characteristics within part numbers T = 25°CaTemperaturecoefficient ofZener voltage Rev ..
MAZ8360-H ,Silicon planar typeFeatures•Extremely low noise voltage caused from the diode (2.4V to 39V,1/3 to 1/10 of our conventi ..
MAZ8390-L ,Silicon planar typeelectrical characteristicsZ Zwithin part numbersReverse current I V ··············· Specified value ..
MAZ9062H ,Small-signal deviceElectrical characteristics within part numbers T = 25°CaZener operatingZener voltageReverse curren ..
MAX6012AEUR-T-MAX6012BEUR-T-MAX6021AEUR-T-MAX6021BEUR-T-MAX6045BEUR-T
Precision / Low-Power / Low-Dropout /
General DescriptionThe MAX6012/MAX6021/MAX6025/MAX6030/MAX6041/
MAX6045/MAX6050 precision, low-dropout, micropower
voltage references are available in miniature SOT23-3
surface-mount packages. They feature a proprietary
curvature-correction circuit and laser-trimmed thin-film
resistors that result in a low temperature coefficient of
<15ppm/°C and initial accuracy of better than 0.2%.
These devices are specified over the extended temper-
ature range.
These series-mode voltage references draw only 27μA
of quiescent supply current and can sink or source up
to 500μA of load current. Unlike conventional shunt-
mode (two-terminal) references that waste supply cur-
rent and require an external resistor, devices in the
MAX6012family offer a supply current that’s virtually
independent of supply voltage (with only a 0.8μA/V vari-
ation with supply voltage) and do not require an external
resistor. Additionally, these internally compensated
devices do not require an external compensation
capacitor and are stable with up to 2.2nF of load capac-
itance. Eliminating the external compensation capacitor
saves valuable board area in space-critical applications.
Their low dropout voltage and supply-independent,
ultra-low supply current make these devices ideal for
battery-operated, low-voltage systems.
ApplicationsHand-Held Equipment
Data Acquisition Systems
Industrial and Process-Control Systems
Battery-Operated Equipment
Hard-Disk Drives
Features0.2% max Initial Accuracy15ppm/°C max Temperature Coefficient35μA max Quiescent Supply Current0.8μA/V Supply Current Variation with VIN±500μA Output Source and Sink Current100mV Dropout at 500μA Load Current0.12μV/μA Load Regulation8μV/V Line RegulationStable with CLOAD= 0 to 2.2nF
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
Typical Operating Circuit19-4777; Rev 2; 10/99
Ordering Information
Selector Guide
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS—MAX6012(VIN= +5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
(Voltages Referenced to GND)
IN.........................................................................-0.3V to +13.5V
OUT.............................................................-0.3V to (VIN+ 0.3V)
Output Short Circuit to GND or IN (VIN< 6V)............Continuous
Output Short Circuit to GND or IN (VIN‡6V).....................60sec
Continuous Power Dissipation (TA= +70°C)
3-Pin SOT23-3 (derate 4.0mW/°C above +70°C)........320mW
Operating Temperature Range...........................-40°C to +85°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10s).................................+300°C
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
ELECTRICAL CHARACTERISTICS—MAX6021(VIN= +5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
ELECTRICAL CHARACTERISTICS—MAX6025(VIN= +5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
ELECTRICAL CHARACTERISTICS—MAX6030(VIN= +5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
ELECTRICAL CHARACTERISTICS—MAX6041(VIN= +5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
ELECTRICAL CHARACTERISTICS—MAX6045(VIN= +5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
MAX6012/6021/6025/6030/6041/6045/6050
Precision, Low-Power, Low-Dropout,
SOT23-3 Voltage References
Note 1:All devices are 100% production tested at TA= +25°C and are guaranteed by design for TA= TMINto TMAX, as specified.
Note 2:Temperature Coefficient is measured by the “box” method, i.e., the maximum DVOUTis divided by the maximum Dt.
Note 3:Temperature Hysteresis is defined as the change in +25°C output voltage before and after cycling the device from TMINto TMAX.
Note 4:Not production tested. Guaranteed by design.
Note 5:Dropout voltage is the minimum input voltage at which VOUTchanges ≤0.2% from VOUTat VIN= 5.0V (VIN= 5.5V for MAX6050).
ELECTRICAL CHARACTERISTICS—MAX6050(VIN= +5.5V, IOUT= 0, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Note 1)
