MAX5206AEUB ,Low-Cost, Voltage-Output, 16-Bit DACs in UMAXApplicationsMAX5204AEUB -40°C to +105°C 10 µMAXLow-Cost VCO/VCXO Frequency ControlMAX5204BEUB -40°C ..
MAX5206AEUB+ ,Low-Cost, Voltage-Output, 16-Bit DACs in µMAXMAX5204–MAX520719-2658; Rev 1; 10/04Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
MAX5207BEUB+ ,Low-Cost, Voltage-Output, 16-Bit DACs in µMAXApplicationsMAX5204AEUB -40°C to +105°C 10 µMAXLow-Cost VCO/VCXO Frequency ControlMAX5204BEUB -40°C ..
MAX520ACAP ,Quad/Octal, 2-Wire Serial 8-Bit DACs with Rail-to-Rail OutputsApplicationsOrdering Information continued at end of data sheet.Minimum Component Analog Systems†MA ..
MAX520ACAP+ ,Quad/Octal, 2-Wire Serial 8-Bit DACs with Rail-to-Rail OutputsGeneral Description ________
MAX520ACPE ,Quad/Octal, 2-Wire Serial 8-Bit DACs with Rail-to-Rail OutputsGeneral Description ________
MAX9706ETX+ ,3-Channel, 2.3W, Filterless Class D Amplifiers with Active CrossoverBlock DiagramMAX9706MAX9707FULL-RANGEAUDIO INTRANSDUCERSFULL-RANGEAUDIO INTRANSDUCERSLOW-FREQUENCYT ..
MAX9708ETN ,20W/40W, Filterless, Spread-Spectrum, Mono/Stereo, Class D AmplifierBlock Diagram22MAX9708SYNCOUT SYNCOUTFS1, FS2 MAX9708FS1, FS2SYNCSYNCRIGHTCHANNELAUDIOCLASS DCLASS ..
MAX9708ETN+ ,20W/40W, Filterless, Spread-Spectrum, Mono/Stereo, Class D AmplifierBlock DiagramMAX9708MAX97082 2SYNCOUT SYNCOUTFS1, FS2 FS1, FS2SYNCSYNCRIGHTCHANNELAUDIOCLASS DCLASS ..
MAX9709ETN , 25W/50W, Filterless, Spread-Spectrum, Stereo/Mono, Class D Amplifier
MAX9709ETN+ ,25W/50W, Filterless, Spread-Spectrum, Stereo/Mono, Class D AmplifierBlock DiagramMAX9709MAX97092 2SYNCOUTSYNCOUTFS1, FS2 FS1, FS2SYNC SYNCRIGHTCHANNELAUDIOCLASS D CLAS ..
MAX970EEE ,Single/Dual/Quad / Micropower / Ultra-Low-Voltage / Rail-to-Rail I/O ComparatorsApplicationsMAX966EUA -40°C to +85°C 8 µMAXMAX967ESA -40°C to +85°C 8 SO_Selector GuideMAX967EUA -4 ..
MAX5204BEUB-MAX5206AEUB
Low-Cost, Voltage-Output, 16-Bit DACs in UMAX
General DescriptionThe MAX5204–MAX5207 serial input, voltage-output 16-
bit digital-to-analog converters (DACs) provide monotonic
16-bit output over temperature without any adjustments.
The MAX5204/MAX5205 operate from a +5V single
power supply and use an external reference ranging
from +4V to VDD, while the MAX5206/MAX5207 operate
from a +3V or +3.3V single power supply and use an
external reference ranging from +2V to VDD. The
MAX5204–MAX5207 DAC output range is typically from
0 to VDD.
The MAX5204–MAX5207 feature a hardware reset input
(CLR) that when pulled low clears the output to zero
code 0000 hex (MAX5205/MAX5207) or resets the out-
put to midscale code 8000 hex (MAX5204/MAX5206).
The 3-wire serial interface is compatible with
SPI™/QSPI™/MICROWIRE™. All devices have a low-
power shutdown mode that reduces the supply current
consumption to 1µA.
The MAX5204–MAX5207 are available in a space-sav-
ing 10-pin µMAX®package and are guaranteed over
the extended temperature range (-40°C to +105°C).
Refer to the MAX5200–MAX5203 data sheet for internal
reference versions.
ApplicationsLow-Cost VCO/VCXO Frequency Control
Industrial Process Control
High-Resolution Offset Adjustment
FeaturesGuaranteed 16-Bit Monotonic10-Pin 5mm ✕3mm µMAX PackageRail-to-Rail Output AmplifierSingle-Supply Operation
+5V (MAX5204/MAX5205)
+3V, +3.3V (MAX5206/MAX5207)Low Power Consumption: 0.5mA Shutdown Mode Reduces Supply Current to 1µASPI/QSPI/MICROWIRE-Compatible 3-Wire Serial
InterfacePower-On-Reset Sets Output to
Midscale (MAX5204/MAX5206)
Zero-Scale (MAX5205/MAX5207)
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
Pin Configuration
Ordering Information19-2658; Rev 1; 10/04
Selector Guide appears at end of data sheet.SPI/QSPI are trademarks of Motorola, Inc.
MICROWIRE is a trademark of National Semiconductor Corp.
µMAX is a registered trademark of Maxim Integrated Products, Inc.
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
ABSOLUTE MAXIMUM RATINGSStresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
VDDto AGND, DGND...............................................-0.3V to +6V
AGND to DGND.........................................……….-0.3V to +0.3V
REF, OUT to AGND.................................…-0.3V to (VDD+ 0.3V)CLR, LDAC, SCLK, DIN, CSto DGND.......-0.3V to (VDD+ 0.3V)
Maximum Current into Any Pin............................................50mA
Continuous Power Dissipation (TA= +70°C)
10-Pin µMAX (derate 5.6mW/°C above +70°C).........444.4mW
Operating Temperature Ranges
MAX520_CUB......................................................0°C to +70°C
MAX520_EUB.........................................…….-40°C to +105°C
Junction Temperature......................................................+150°C
Storage Temperature Range.............................-60°C to +150°C
Lead Temperature (soldering, 10s).................................+300°C
ELECTRICAL CHARACTERISTICS—MAX5204/MAX5205(VDD= +4.75V to +5.25V, fSCLK= 10MHz (50% duty cycle), VREF= 4.096V, output load = 10kΩin parallel with 250pF, TA= TMINto
TMAX, unless otherwise noted. Typical values are at TA= +25°C.)
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
ELECTRICAL CHARACTERISTICS—MAX5204/MAX5205 (continued)(VDD= +4.75V to +5.25V, fSCLK= 10MHz (50% duty cycle), VREF= 4.096V, output load = 10kΩin parallel with 250pF, TA= TMINto
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
ELECTRICAL CHARACTERISTICS—MAX5206/MAX5207(VDD= +2.7V to +3.6V, fSCLK= 10MHz (50% duty cycle),VREF= 2.048V,output load = 10kΩin parallel with 250pF, TA= TMINto TMAX,
unless otherwise noted. Typical values are at TA= +25°C.)
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
Note 1:Static performance tested at VDD= +5.0V (MAX5204/MAX5205) and at VDD= +3.0V (MAX5206/MAX5207).
Note 2:INL and DNL are guaranteed for outputs between 0.5V to (VDD- 0.5V).
Note 3:Guaranteed monotonic.
Note 4:VREF= 4.096V (MAX5204/MAX5205) and VREF= 2.048V (MAX5206/MAX5207).
Note 5:RL= ∞, digital inputs are at VDDor DGND.
ELECTRICAL CHARACTERISTICS—MAX5206/MAX5207 (continued)(VDD= +2.7V to +3.6V, fSCLK= 10MHz (50% duty cycle),VREF= 2.048V,output load = 10kΩin parallel with 250pF, TA= TMINto TMAX,
unless otherwise noted. Typical values are at TA= +25°C.)
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
Typical Operating Characteristics(VDD= +5V, VREF= 4.096V, TA= +25°C, unless otherwise noted.)
MAX5204–MAX5207
Low-Cost, Voltage-Output, 16-Bit DACs in µMAX
Typical Operating Characteristics (continued)(VDD= +5V, VREF= 4.096V, TA= +25°C, unless otherwise noted.)