MAX4715EXK-T ,0.4 / Low-Voltage / Single-Supply SPST Analog Switches in SC70ApplicationsPower RoutingBattery-Operated EquipmentAudio and Video Signal RoutingLow-Voltage Data-A ..
MAX4716EXK+T ,0.4Ω, Low-Voltage, Single-Supply SPST Analog SwitchesELECTRICAL CHARACTERISTICS—Single +3V Supply(V+ = +2.7V to +3.6V, V = +1.4V, V = +0.5V, T = T to T ..
MAX4716EXK-T ,0.4 / Low-Voltage / Single-Supply SPST Analog Switches in SC70ELECTRICAL CHARACTERISTICS—Single +3V Supply(V+ = +2.7V to +3.6V, V = +1.4V, V = +0.5V, T = T to T ..
MAX4717EBC ,4.5Ω/20Ω, 300MHz Bandwidth, Dual SPDT Analog Switches in UCSPFeatures♦ USB 1.1 Signal Switching CompliantThe MAX4717/MAX4718 low-voltage, low on-resistance(TID ..
MAX4717EBC+ ,4.5Ω/20Ω, 300MHz Bandwidth, Dual SPDT Analog Switches in UCSPFeatures♦ USB 1.1 Signal Switching CompliantThe MAX4717/MAX4718 low-voltage, low on-resistance(TID ..
MAX4717EBC+T ,4.5Ω/20Ω, 300MHz Bandwidth, Dual SPDT Analog Switches in UCSPApplicationsOrdering InformationUSB 1.1 Signal Switching CircuitsPIN/BUMP- TOPPART TEMP RANGEBatter ..
MAX8866TEUA+ ,Dual, Low-Dropout, 100mA Linear Regulators
MAX8867EUK25-T ,Low-noise, low-dropout, 150mA linear regulator. Preset output voltage 2.50V
MAX8867EUK28+T ,Low-noise, low-dropout, 150mA linear regulator. Preset output voltage 2.80V
MAX8867EUK28-T ,Low-noise, low-dropout, 150mA linear regulator. Preset output voltage 2.80V
MAX8867EUK29-T ,Low-noise, low-dropout, 150mA linear regulator. Preset output voltage 2.84V
MAX8867EUK29-T ,Low-noise, low-dropout, 150mA linear regulator. Preset output voltage 2.84V
MAX4715EXK-T-MAX4716EXK-T
0.4 / Low-Voltage / Single-Supply SPST Analog Switches in SC70
General DescriptionThe MAX4715/MAX4716 are low on-resistance, low-
voltage, single-pole/single-throw (SPST) analog switch-
es that operate from a +1.6V to +3.6V single supply.
The MAX4715 is normally open (NO), and the MAX4716
is normally closed (NC). These devices also have fast
switching speeds (tON= 18ns max, tOFF= 12ns max).
When powered from a +3V supply, the MAX4715/
MAX4716 offer 0.4Ωmax on-resistance (RON) with 0.1Ω
max RONflatness. Their digital logic inputs are +1.8V
CMOS compatible when using a single +3V supply.
The MAX4715 is pin compatible with the MAX4594, and
the MAX4716 is pin compatible with the MAX4595. The
MAX4715/MAX4716 are available in SC70-5 packages.
ApplicationsPower Routing
Battery-Operated Equipment
Audio and Video Signal Routing
Low-Voltage Data-Acquisition Systems
Communications Circuits
PCMCIA Cards
Cellular Phones
Modems
Hard Drives
FeaturesLow RON
0.4Ωmax (+3V Supply)
1.2Ωmax (+1.8V Supply)0.1Ωmax RONFlatness (+3V Supply)+1.6V to +3.6V Single-Supply Operation Available in 5-Pin SC70 PackagesFast Switching: tON= 18ns max, tOFF= 12ns max+1.8V CMOS Logic Compatible (+3V Supply)Pin Compatible with MAX4594 (MAX4715)
Pin Compatible with MAX4595 (MAX4716)
MAX4715/MAX4716
0.4Ω, Low-Voltage, Single-Supply
SPST Analog Switches in SC7019-2008; Rev 0; 4/01
Pin Configurations/Functional Diagrams/Truth Tables
Ordering Information
MAX4715/MAX4716
0.4Ω, Low-Voltage, Single-Supply
SPST Analog Switches in SC70
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS—Single +3V Supply(V+ = +2.7V to +3.6V, VIH= +1.4V, VIL= +0.5V, TA= TMINto TMAX, unless otherwise noted. Typical values are at V+ = +3.0V and
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Voltages Referenced to GND
V+, IN.......................................................................-0.3V to +4V
COM, NO, NC (Note 1).................................-0.3V to (V+ + 0.3V)
Continuous Current NO, NC to COM .............................±300mA
Peak Switch Current NO, NC to COM
(pulsed at 1ms, 10% duty cycle max).......................±600mA
Continuous Power Dissipation (TA= +70°C)
5-Pin SC70 (derate 3.1mW/°C above +70°C)..............247mW
Operating Temperature Range
MAX471_EXK...................................................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10s)................................+300°C
Note 1:Signals on NO, NC, or COM exceeding V+ or GND are clamped by internal diodes.
MAX4715/MAX4716
0.4Ω, Low-Voltage, Single-Supply
SPST Analog Switches in SC70
ELECTRICAL CHARACTERISTICS—Single +1.8V Supply
ELECTRICAL CHARACTERISTICS—Single +3V Supply (continued)(V+ = +2.7V to +3.6V, VIH= +1.4V, VIL= +0.5V, TA= TMINto TMAX, unless otherwise noted. Typical values are at V+ = +3.0V and = +25°C.) (Notes 2, 3)
MAX4715/MAX4716
0.4Ω, Low-Voltage, Single-Supply
SPST Analog Switches in SC70
Typical Operating Characteristics(TA = +25°C, unless otherwise noted.)
Note 2:The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3:SC70-packaged parts are 100% tested at +25°C. Limits across the full temperature range are guaranteed by design and
correlation.
Note 4:Flatness is defined as the difference between the maximum and minimum values of on-resistance as measured over the
specified analog signal range.
Note 5:Off-Isolation = 20log10[VCOM/ (VNCor VNO)], VCOM= output, VNCor VNO= input to off switch.
Note 6:Guaranteed by design.
ELECTRICAL CHARACTERISTICS—Single +1.8V Supply (continued)(V+ = +1.8V, VIH= +1V, VIL= +0.4V, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.) (Notes 2, 3)
MAX4715/MAX4716
0.4Ω, Low-Voltage, Single-Supply
SPST Analog Switches in SC70TURN-ON/OFF TIMES
vs. TEMPERATURE
MAX4715/16 toc04
TEMPERATURE (°C)
tON
OFF
(ns)
ON/OFF-LEAKAGE CURRENT
vs. TEMPERATUREMAX4715/16 toc05
ON/OFF-LEAKAGE CURRENT (nA)
TEMPERATURE (°C)
CHARGE INJECTION vs. COM VOLTAGE
MAX4715/16 toc06
VCOM (V)
Q (pC)
10k100k1000k1M10M100M
FREQUENCY RESPONSE
MAX4715/16 toc07
FREQUENCY (Hz)
LOSS (dB)
LOGIC THRESHOLD VOLTAGE
vs. SUPPLY VOLTAGE
MAX4715/16 toc08
SUPPLY VOLTAGE (V)
LOGIG THRESHOLD VOLTAGE (V)1k100k
TOTAL HARMONIC DISTORTION
vs. FREQUENCYMAX4715/16 toc09
FREQUENCY (Hz)
THD (%)
10010k
Typical Operating Characteristics (continued)(TA = +25°C, unless otherwise noted.)
Pin Description
MAX4715/MAX4716
0.4Ω, Low-Voltage, Single-Supply
SPST Analog Switches in SC70
Detailed DescriptionThe MAX4715/MAX4716 are low on-resistance (RON),
low-voltage, single-pole/single-throw (SPST) analog
switches that operate from a +1.6V to +3.6V single sup-
ply. The MAX4715 is normally open (NO), and the
MAX4716 is normally closed (NC).
When powered from a +3V supply, their 0.4ΩRON
allows high continuous currents to be switched in a
variety of applications.
Applications Information
Logic InputsThe MAX4715/MAX4716 logic inputs can be driven up
to +3.6V regardless of the supply voltage. For example,
with a +3.3V supply, IN may be driven low to GND and
high to +3.6V. Driving IN Rail-to-Rail®minimizes power
consumption.
Analog Signal LevelsAnalog signals that range over the entire supply voltage
(V+ to GND) can be passed with very little change in
on-resistance (see Typical Operating Characteristics).
The switches are bidirectional, so the NO, NC, and
COM pins can be used as either inputs or outputs.
Figure 1. Switching Time
Test Circuits/Timing DiagramsFigure 2. Charge Injection
Rail-to-Rail is a registered trademark of Nippon Motorola Ltd.
