MAX4678EUE ,2 / Quad / SPST / CMOS Analog SwitchesApplicationsMAX4678EPE -40°C to +85°C 16 DIPReed Relay Replacement Avionics MAX4679EUE -40°C to +85 ..
MAX4678EUE+ ,2Ω, Quad, SPST, CMOS Analog SwitchesELECTRICAL CHARACTERISTICS–Dual Supplies(V+ = +5V ±10%, V- = -5V ±10%, V = +2.7V to V+, GND = 0, V ..
MAX4678EUE+ ,2Ω, Quad, SPST, CMOS Analog SwitchesFeaturesThe MAX4677/MAX4678/MAX4679 quad analog switch-♦ On-Resistance 1.6Ω maxes feature 1.6Ω max ..
MAX467CPE ,Two-Channel, Triple/Quad RGB Video Switches and BuffersELECTRICAL CHARACTERISTICS(V+ = 5V, V- = -5V, -2V ≤ V ≤ +2V, R = 75Ω, unless otherwise noted.)IN LO ..
MAX4680CAE ,1.25 / Dual SPST / CMOS Analog SwitchesApplicationsMAX4680CWE 0°C to +70°C 16 Wide SOMAX4680CPE 0°C to +70°C 16 Plastic DIPReed Relay Repl ..
MAX4680CWE ,1.25 / Dual SPST / CMOS Analog SwitchesELECTRICAL CHARACTERISTICS—Dual Supplies(V+ = +15V, V- = -15V, V = +5V, V = +2.4V, V = +0.8V, T = T ..
MAX8860EUA18+ ,Low-Dropout, 300mA Linear Regulator in µMAXMAX886019-1422; Rev 2; 1/01Low-Dropout, 300mA Linear Regulator in µMAX
MAX8860EUA18+T ,Low-Dropout, 300mA Linear Regulator in µMAXMAX886019-1422; Rev 2; 1/01Low-Dropout, 300mA Linear Regulator in µMAX
MAX8860EUA25 ,Low-Dropout / 300mA Linear Regulator in MAXELECTRICAL CHARACTERISTICS(V = +3.6V, C = 33nF, T = -40°C to +85°C, unless otherwise noted. Typical ..
MAX8860EUA25 ,Low-Dropout / 300mA Linear Regulator in MAXfeatures include a 10nA, logic-controlled shut- Small, Space-Saving µMAX Package down mode, short ..
MAX8860EUA25+ ,Low-Dropout, 300mA Linear Regulator in µMAXApplicationsWireless HandsetsDSP Core PowerOrdering InformationPCMCIA CardsPIN- VOUTPART TEMP RANGE ..
MAX8860EUA25+T ,Low-Dropout, 300mA Linear Regulator in µMAXELECTRICAL CHARACTERISTICS(V = 3.6V, C = 33nF, T = -40°C to +85°C, unless otherwise noted. Typical ..
MAX4678EPE-MAX4678EUE
2 / Quad / SPST / CMOS Analog Switches
General DescriptionThe MAX4677/MAX4678/MAX4679 quad analog switch-
es feature 1.6Ωmax on-resistance (RON) when operat-
ing from a dual ±5V supply. RONis matched between
channels to 0.3Ωmax and is flat (0.4Ωmax) over the
specified signal range. Each switch can handle Rail-to-
Rail®analog signals. Off-leakage current is 0.1nA at
+25°C. These switches are ideal in low-distortion appli-
cations and are the preferred solution over mechanical
relays in automated test equipment. They have low
power requirements, require less board space, and are
more reliable than mechanical relays.
The MAX4677 has four normally closed (NC) switches,
and the MAX4678 has four normally open (NO) switch-
es. The MAX4679 has two NC and two NO switches
and features guaranteed break-before-make switching.
The MAX4677/MAX4678/MAX4679 operate from either
a single +2.7V to +11V or dual ±2.7V to ±5.5V supplies,
making them ideal for use in digital card applications
and single-ended 75Ωsystems.
These devices feature a separate logic supply input
that operates from +2.7V to V+, allowing independent
logic and analog supplies.
________________________Applications
FeaturesOn-Resistance 1.6ΩmaxOn-Resistance Flatness 0.4ΩmaxOn-Resistance Matching 0.3ΩmaxDual ±2.7V to ±5.5V or Single +2.7V to +11V
Supply RangeTTL/CMOS-Logic CompatibleCrosstalk -84dB at 1MHzOff-Isolation -65dB at 1MHz-3dB Bandwidth: 66MHzRail-to-Rail Signal Range
MAX4677/MAX4678/MAX4679
2Ω, Quad, SPST, CMOS Analog Switches ______________________Pin Configurations/Functional Diagrams/Truth T
ables 19-1713; Rev 0; 4/00
Ordering InformationRail-to-Rail is a registered trademark of Nippon Motorola, Ltd.
Reed Relay Replacement
Test Equipment
Communications Systems
Audio Signal Routing
Avionics
ADC Systems
Data-Acquisition Systems
PBX/PABX Systems
MAX4677/MAX4678/MAX4679
2Ω, Quad, SPST, CMOS Analog Switches
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS–Dual Supplies(V+ = +5V ±10%, V- = -5V ±10%, VL= +2.7V to V+, GND = 0, VIH= +2.4V, VIL= +0.8V, TA= TMINto TMAX, unless otherwise noted.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
V+ to GND..............................................................-0.3V to +12V
V- to GND...............................................................+0.3V to -12V
V+ to V-................................................................................+12V
VL, IN_ to GND (Note 1)...............................-0.3V to (V+ + 0.3V)
VCOM_,VNC_, VNO_(Note 1)............................................V- to V+
Current (any terminal).......................................................±50mA
Continuous Current (COM_, NC_, NO_).........................±100mA
Peak Current (COM_, NC_, NO_
pulsed at 1ms 10% duty cycle).................................±200mA
Continuous Power Dissipation (TA= +70°C)
16-Pin Plastic DIP (derate 10.5mW/°C above +70°C)..842mW
16-Pin TSSOP (derate 5.7mW/°C above +70°C)..........457mW
Operating Temperature Range...........................-40°C to +85°C
Storage Temperature Range.............................-65°C to +150°C
Junction Temperature......................................................+150°C
Lead Temperature (soldering, 10s).................................+300°C
Note 1:Signals on NC_, NO_, COM_, or IN_ exceeding V+ or V- are clamped by internal diodes. Limit forward diode current to
maximum current rating.
MAX4677/MAX4678/MAX4679
2Ω, Quad, SPST, CMOS Analog Switches
ELECTRICAL CHARACTERISTICS–Dual Supplies (continued)(V+ = +5V ±10%, V- = -5V ±10%, VL= +2.7V to V+, GND = 0, VIH= +2.4V, VIL= +0.8V, TA= TMINto TMAX, unless otherwise noted.
MAX4677/MAX4678/MAX4679
2Ω, Quad, SPST, CMOS Analog Switches
ELECTRICAL CHARACTERISTICS–Single Supply(V+ = +5V ±10%, V- = 0, VL= +2.7V to V+, GND = 0, VIH= +2.4V, VIL= +0.8V, TA= TMINto TMAX, unless otherwise noted. Typical
MAX4677/MAX4678/MAX4679
2Ω, Quad, SPST, CMOS Analog Switches
ELECTRICAL CHARACTERISTICS–Single Supply (continued)(V+ = +5V ±10%, V- = 0, VL= +2.7V to V+, GND = 0, VIH= +2.4V, VIL= +0.8V, TA= TMINto TMAX, unless otherwise noted. Typical
Typical Operating Characteristics(TA = +25°C, unless otherwise noted.)
Note 3: ∆RON = RON(MAX) - RON(MIN).
Note 4: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over thespecified analog signal ranges.
Note 5: Leakage parameters are 100% tested at maximum-rated hot operating temperature and the highest supply voltage, andguaranteed by correlation at +25°C.
MAX4677/MAX4678/MAX4679
2Ω, Quad, SPST, CMOS Analog Switches
Typical Operating Characteristics (continued)(TA= +25°C, unless otherwise noted.)
