MAX4665CSE ,5 / Quad / SPST / CMOS Analog Switchesapplications where current switching is♦ Rail-to-Rail Signal Handlingrequired. They have low power ..
MAX4665CSE ,5 / Quad / SPST / CMOS Analog SwitchesFeaturesThe MAX4664/MAX4665/MAX4666 quad analog switch-♦ Low On-Resistance (5Ω max)es feature 5Ω ma ..
MAX4665CSE+ ,5 Ohm, Quad, SPST, CMOS Analog Switchesapplications and are the pre-♦ Guaranteed Break-Before-Make (MAX4666)ferred solution over mechanica ..
MAX4665ESE ,5 / Quad / SPST / CMOS Analog SwitchesMAX4664/MAX4665/MAX466619-1504; Rev 0; 7/995Ω, Quad, SPST,CMOS Analog Switches
MAX4665ESE+ ,5 Ohm, Quad, SPST, CMOS Analog Switchesapplications where current switching is♦ Rail-to-Rail Signal Handlingrequired. They have low power ..
MAX4666CSE ,5 / Quad / SPST / CMOS Analog SwitchesApplicationsMAX4664ESE -40°C to +85°C 16 Narrow SOReed Relay Replacement PBX, PABX SystemsMAX4664EP ..
MAX883CSA-T ,5V/3.3V or Adjustable, Low-Dropout, Low-IQ, 200mA Linear Regulator with Standby ModeApplicationsOrdering Information continued at end of data sheet.*Dice are tested at T = +25°C, DC p ..
MAX883EPA ,5V/3.3V or Adjustable, Low-Dropout, Low IQ, 200mA Linear Regulatorsfeatures a 7µA standby mode that disablesStandby Modethe output but keeps the reference, low-batter ..
MAX883EPA ,5V/3.3V or Adjustable, Low-Dropout, Low IQ, 200mA Linear RegulatorsMAX882/MAX883/MAX88419-0275; Rev 0; 12/945V/3.3V or Adjustable, Low-Dropout, Low I , 200mA Linear R ..
MAX883ESA ,5V/3.3V or Adjustable, Low-Dropout, Low IQ, 200mA Linear Regulatorsfeatures a 7µA standby mode that disablesStandby Modethe output but keeps the reference, low-batter ..
MAX883ESA ,5V/3.3V or Adjustable, Low-Dropout, Low IQ, 200mA Linear RegulatorsFeaturesThe MAX882/MAX883/MAX884 linear regulators maxi-' Guaranteed 200mA Output Current at mize b ..
MAX883ESA+ ,5V/3.3V or Adjustable, Low-Dropout, Low-IQ, 200mA Linear Regulator with Standby Modefeatures a 7µA standby mode that disables♦ Low-Battery Detection Comparatorthe output but keeps the ..
MAX4664CSE-MAX4664ESE-MAX4665CSE-MAX4665ESE-MAX4666CSE-MAX4666EPE-MAX4666ESE
5 / Quad / SPST / CMOS Analog Switches
General DescriptionThe MAX4664/MAX4665/MAX4666 quad analog switch-
es feature 5Ωmax on-resistance. On-resistance is
matched between switches to 0.5Ωmax and is flat (0.5Ω
max) over the specified signal range. Each switch can
handle Rail-to-Rail®analog signals. The off-leakage cur-
rent is only 5nA max at +85°C. These analog switches
are ideal in low-distortion applications and are the pre-
ferred solution over mechanical relays in automatic test
equipment or in applications where current switching is
required. They have low power requirements, require
less board space, and are more reliable than mechanical
relays.
The MAX4664 has four normally closed (NC) switches,
the MAX4665 has four normally open (NO) switches, and
the MAX4666 has two NC and two NO switches that
guarantee break-before-make switching times.
These switches operate from a single +4.5V to +36V
supply or from dual ±4.5V to ±20V supplies. All digital
inputs have +0.8V and +2.4V logic thresholds, ensuring
TTL/CMOS-logic compatibility when using ±15V sup-
plies or a single +12V supply.
ApplicationsReed Relay ReplacementPBX, PABX Systems
Test EquipmentAudio-Signal Routing
Communication SystemsAvionics
FeaturesLow On-Resistance (5Ωmax)Guaranteed RONMatch Between Channels
(0.5Wmax)Guaranteed RONFlatness over Specified Signal
Range (0.5Wmax)Guaranteed Break-Before-Make (MAX4666)Rail-to-Rail Signal HandlingGuaranteed ESD Protection > 2kV per
Method 3015.7+4.5V to +36V Single-Supply Operation
±4.5V to ±20V Dual-Supply Operation TTL/CMOS-Compatible Control Inputs
MAX4664/MAX4665/MAX4666
5Ω, Quad, SPST,
CMOS Analog Switches
Pin Configurations/Functional Diagrams/Truth Tables19-1504; Rev 0; 7/99
Ordering InformationRail-to-Rail is a registered trademark of Nippon Motorola, Ltd.
MAX4664/MAX4665/MAX4666
5Ω, Quad, SPST,
CMOS Analog Switches
ABSOLUTE MAXIMUM RATINGS
Note 1:Signals on NC_, NO_, COM_, or IN_ exceeding V+ or V- are clamped by internal diodes. Limit forward-diode current to
maximum current rating.
V+ to GND..............................................................-0.3V to +44V
V- to GND..............................................................+0.3V to -44V
V+ to V-...................................................................-0.3V to +44Vto GND........................................(GND - 0.3V) to (V+ + 0.3V)
All Other Pins to DGND (Note 1).........(V- - 0.3V) to (V+ + 0.3V)
Continuous Current (COM_, NO_, NC_) ........................±100mA
Peak Current (COM_, NO_, NC_)
(pulsed at 1ms, 10% duty cycle)...............................±300mA
Continuous Power Dissipation (TA= +70°C)
Narrow SO (derate 8.70mW/°C above +70°C)...............696mW
Plastic DIP (derate 10.53mW/°C above +70°C)..............842mW
Operating Temperature Ranges
MAX466_C_E ......................................................0°C to +70°C
MAX466_E_E....................................................-40°C to +85°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10sec).............................+300°C
ELECTRICAL CHARACTERISTICS—Dual Supplies(V+ = +15V, V- = -15V, VL= +5V, VIN_H= +2.4V, VIN_L= +0.8V, TA= TMINto TMAX, unless otherwise noted. Typical values are at = +25°C.) (Note 2)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
MAX4664/MAX4665/MAX4666
5Ω, Quad, SPST,
CMOS Analog Switches
ELECTRICAL CHARACTERISTICS—Dual Supplies (continued)(V+ = +15V, V- = -15V, VL= +5V, VIN_H= +2.4V, VIN_L= +0.8V, TA= TMINto TMAX, unless otherwise noted. Typical values are at = +25°C.) (Note 2)
MAX4664/MAX4665/MAX4666
5Ω, Quad, SPST,
CMOS Analog Switches
ELECTRICAL CHARACTERISTICS—Single Supply(V+ = +12V, V- = 0, VL= +5V, VIN_H= +2.4V, VIN_L= +0.8V, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.)
(Note 2)
MAX4664/MAX4665/MAX4666
5Ω, Quad, SPST,
CMOS Analog Switches
ELECTRICAL CHARACTERISTICS—Single Supply (continued)(V+ = +12V, V- = 0, VL= +5V, VIN_H= +2.4V, VIN_L= +0.8V, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.)
(Note 2)
Note 2:The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3:Guaranteed by design.
Note 4:DRON= RON(MAX)- RON(MIN).
Note 5:Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal range.
Note 6:Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25°C.
Note 7:Off-isolation = 20log10[VCOM_/ (VNC_or VNO_)], VCOM_= output, VNC_or VNO_= input to off switch.
Note 8:Between any two switches.
Note 9:Leakage testing at single supply is guaranteed by testing with dual supplies.
MAX4664/MAX4665/MAX4666
5Ω, Quad, SPST,
CMOS Analog Switches
Typical Operating Characteristics(TA= +25°C, unless otherwise noted.)
