MAX3013EGP ,+1.2 to +3.6 V, 100 Mbps, 0.1 mA, 8-channel level translatorApplicationsI/O V 4 4 17 I/O V 4L CCLow-Voltage ASIC Level TranslationV 5 16 VL CCCell Phones MAX30 ..
MAX3013EUP ,+1.2 to +3.6 V, 100 Mbps, 0.1 mA, 8-channel level translatorFeaturesThe MAX3013–MAX3022 8-channel level translators pro-♦ 100Mbps Guaranteed Data Rate vide the ..
MAX301CPE ,Precision, Dual, High-Speed Analog SwitchesELECTRICAL CHARACTERISTICS(V+ = 15V, V- = -15V, V = +5V, GND = 0V, V = +2.4V, V = +0.8V, T = T to T ..
MAX301CSE ,Precision, Dual, High-Speed Analog SwitchesELECTRICAL CHARACTERISTICS(V+ = 15V, V- = -15V, V = +5V, GND = 0V, V = +2.4V, V = +0.8V, T = T to T ..
MAX301CSE ,Precision, Dual, High-Speed Analog SwitchesMAX301/MAX303/MAX30519-0159; Rev 0; 9/93Precision, Dual, High-Speed Analog Switches________________ ..
MAX301EPE ,Precision, Dual, High-Speed Analog SwitchesApplicationsMAX301EPE -40°C to +85°C 16 Plastic DIPSample-and-Hold Circuits Military Radios MAX301E ..
MAX6194BESA+ ,Precision, Micropower, Low-Dropout Voltage Referencesapplications that require fast settling,Analog-to-Digital and Digital-to-Analog Convertersand are s ..
MAX6195AESA ,Precision / Micropower / Low-Dropout Voltage ReferencesApplicationsguaranteed for source and sink currents up to 500µA.These devices are internally compen ..
MAX6195AESA ,Precision / Micropower / Low-Dropout Voltage ReferencesApplicationsguaranteed for source and sink currents up to 500µA.These devices are internally compen ..
MAX6195BESA ,Precision / Micropower / Low-Dropout Voltage ReferencesMAX6190–MAX6195/MAX619819-1408; Rev 1; 3/99Precision, Micropower, Low-Dropout Voltage References
MAX6195BESA+ ,Precision, Micropower, Low-Dropout Voltage ReferencesELECTRICAL CHARACTERISTICS—MAX6190(V = 5V, I = 0nA, T = T to T , unless otherwise noted. Typical va ..
MAX6195CESA ,Precision / Micropower / Low-Dropout Voltage ReferencesMAX6190–MAX6195/MAX619819-1408; Rev 1; 3/99Precision, Micropower, Low-Dropout Voltage References
MAX3013EGP-MAX3013EUP
+1.2 to +3.6 V, 100 Mbps, 0.1 mA, 8-channel level translator
General DescriptionThe MAX3013–MAX3022 8-channel level translators pro-
vide the level shifting necessary to allow 100Mbps data
transfer in a multivoltage system. Externally applied volt-
ages, VCCand VL, set the logic levels on either side of
the device. Logic signals present on the VLside of the
device appear as a higher voltage logic signal on the
VCCside of the device, and vice-versa.
The MAX3013–MAX3022 feature an EN input that, when
at logic low, places all inputs/outputs on both sides in
tristate and reduces the VCCand VL supply currents to
0.1µA. These devices operate at a guaranteed data rate
of 100Mbps for VL> 1.8V.
The MAX3013–MAX3022 accept a VCCvoltage from
+1.65V to +3.6V and a VLvoltage from +1.2V to (VCC-
0.4V), making them ideal for data transfer between low-
voltage ASICs/PLDs and higher voltage systems. The
MAX3013–MAX3022 are available in 5 x 4 UCSP™, 20-
pin 5mm x 5mm QFN, and 20-pin TSSOP packages.
ApplicationsLow-Voltage ASIC Level Translation
Cell Phones
SPI™, MICROWIRE™ Level Translation
Portable POS Systems
Portable Communication Devices
GPS
Telecommunications Equipment
Features100Mbps Guaranteed Data Rate Bidirectional Level Translation (MAX3013)Unidirectional Level Translation
(MAX3014–MAX3022)VLOperation Down to +1.2V Ultra-Low 0.1µA Supply Current in ShutdownLow-Quiescent Current (0.1µA)UCSP, QFN, and TSSOP Packages
MAX3013–MAX3022
+1.2V to +3.6V, 0.1µA, 100Mbps,
8-Channel Level Translators
Ordering Information19-3156; Rev 1; 8/04
Ordering Information continued at end of data sheet.
Typical Operating Circuit appears at end of data sheet.
Pin Configurations*EP = Exposed paddle.
UCSP is a trademark of Maxim Integrated Products, Inc.
SPI is a trademark of Motorola, Inc.
MICROWIRE is a trademark of National Semiconductor Corp.
MAX3013–MAX3022
+1.2V to +3.6V, 0.1µA, 100Mbps,
8-Channel Level Translators
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS(VCC= +1.65V to +3.6V, VL= +1.2V to (VCC- 0.4V) (Note 1), EN = VL, CIOVL≤15pF, CIOVCC≤40pF, TA= TMINto TMAX. Typical val-
ues are at VCC= +3.3V, VL= +1.8V, TA= +25°C.) (Note 2)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
(All voltages referenced to GND.)
VCC...........................................................................-0.3V to +4V
VL..............................................................................-0.3V to +4V
I/O VCC.......................................................-0.3V to (VCC+ 0.3V)
I/O VL.............................................................-0.3V to (VL+ 0.3V).................................................................-0.3V to (VL+ 0.3V)
Short-Circuit Duration I/O VL, I/O VCCto GND...........Continuous
Continuous Power Dissipation (TA= +70°C)
20-Pin TSSOP (derate 11mW/°C above +70°C)..........879mW
5 x 4 UCSP (derate 10mW/°C above +70°C)..............800mW
20-Pin QFN (derate 20.0mW/°C above +70°C).............1.60W
Operating Temperature Range...........................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10s).................................+300°C
MAX3013–MAX3022
+1.2V to +3.6V, 0.1µA, 100Mbps,
8-Channel Level Translators
ELECTRICAL CHARACTERISTICS (continued)(VCC= +1.65V to +3.6V, VL= +1.2V to (VCC- 0.4V) (Note 1), EN = VL, CIOVL≤15pF, CIOVCC≤40pF, TA= TMINto TMAX. Typical val-
ues are at VCC= +3.3V, VL= +1.8V, TA= +25°C.) (Note 2)
TIMING CHARACTERISTICS(VCC= +1.65V to +3.6V, VL= +1.2V to (VCC- 0.4V) (Note 1), EN = VL, CIOVL≤15pF, CIOVCC≤40pF, TA= TMINto TMAX. Typical val-
MAX3013–MAX3022
+1.2V to +3.6V, 0.1µA, 100Mbps,
8-Channel Level Translatorsstarting up and shutting down conditions.
Note 2:All units are 100% production tested at TA= +25°C. Limits over the operating temperature range are guaranteed by design
and not production tested.
Note 3:Not production tested. Guaranteed by design.
TIMING CHARACTERISTICS (continued)(VCC= +1.65V to +3.6V, VL= +1.2V to (VCC- 0.4V) (Note 1), EN = VL, CIOVL≤15pF, CIOVCC≤40pF, TA= TMINto TMAX. Typical val-
ues are at VCC= +3.3V, VL= +1.8V, TA= +25°C.) (Note 2)
Typical Operating Characteristics(Data rate = 100Mbps, VCC= 3.3V, VL= 1.8V, TA= +25°C, unless otherwise noted.)
MAX3013–MAX3022
+1.2V to +3.6V, 0.1µA, 100Mbps,
8-Channel Level Translators
Typical Operating Characteristics (continued)(Data rate = 100Mbps, VCC= 3.3V, VL= 1.8V, TA= +25°C, unless otherwise noted.)
