LMC6036IMX/NOPB ,Low Power 2.7V Single Supply CMOS Operational Amplifier 14-SOIC -40 to 85Electrical Characteristics+−Unless otherwise specified, all limits ensured for T = 25°C, V = 2.7V, ..
LMC6041AIM ,CMOS Single Micropower Operational Amplifier
LMC6041AIN ,CMOS Single Micropower Operational Amplifier
LMC6041AIN ,CMOS Single Micropower Operational Amplifier
LMC6041IMX ,CMOS Single Micropower Operational Amplifier
LMC6041IMX ,CMOS Single Micropower Operational Amplifier
LQA03TC600 , 600 V, 3 A Q-Series PFC Diode
LQA05TC600 , 600 V, 5 A Q-Series PFC Diode
LQA20B300C , 300 V, 20 A Q-Series Common-Cathode Diode
LQFP100 , High-density value line, advanced ARM-based 32-bit MCU with 256 to 512 KB Flash, 16 timers, ADC, DAC & 11 comm interfaces
LQG11A2N2S00 , CHIP COIL
LQG15HN12NJ02D , Chip Inductor (Chip Coil) for High Frequency Multilayer Type
LMC6036IMX/NOPB
Quad 2.7V Single Supply CMOS Operational Amplifier
LMC6035, LMC6035-Q1, LMC6036
www.ti.com SNOS875G –JANUARY 2000–REVISED APRIL 2013
LMC6035/LMC6035-Q1/LMC6036 Low Power 2.7V Single Supply CMOS Operational
Amplifiers
Checkfor Samples: LMC6035, LMC6036
1FEATURES APPLICATIONS (Typical Unless Otherwise Noted) • Filters LMC6035in DSBGA Package • High Impedance Bufferor Preamplifier Ensured 2.7V, 3V, 5V and 15V Performance • Battery Powered Electronics Specified for2 kΩ and 600Ω Loads • Medical Instrumentation Wide Operating Range: 2.0Vto 15.5V • Automotive Applications
DESCRIPTION• Ultra Low Input Current: 20fAThe LMC6035/6is an economical, low voltage op
• Rail-to-Rail Output Swing amp capableof rail-to-rail output swing into loadsof
– @ 600Ω: 200mV from Either Railat 2.7V 600Ω. LMC6035is availableina chip sized package
@ 100kΩ: 5mV from Either Railat 2.7V (8-Bump DSBGA) using micro SMD package
technology. Both allow for single supply operation
• High Voltage Gain: 126dB and are ensured for 2.7V, 3V, 5V and 15V supply
• Wide Input Common-Mode Voltage Range voltage. The 2.7 supply voltage correspondsto the
-0.1Vto 2.3VatVS= 2.7V End-of-Life voltage (0.9V/cell) for three NiCdor NiMH
batteriesin series, making the LMC6035/6 well suited
• Low Distortion: 0.01%at 10kHz for portable and rechargeable systems. It also
• LMC6035 Dual LMC6036 Quad featuresa well behaved decreaseinits specifications
• See AN-1112 (Literature Number SNVA009) for at supply voltages belowits ensured 2.7V operation.
DSBGA Considerations This providesa “comfort zone” for adequate operation voltages significantly below 2.7V.Its ultra low input
• AEC-Q100 Grade3 Qualified (LMC6035-Q1) currents (IIN) makesit well suited for low power active
filter application, becauseit allows the useof higher
resistor values and lower capacitor values. In
addition, the drive capabilityof the LMC6035/6 gives
these op ampsa broad rangeof applications for low
voltage systems.
Connection Diagram
Top View
Figure1. 8-Bump DSBGA Package
(Bump Side Down)
See Package Number YZR0008