LM358WDT ,Standard Ground Sense Operational AmplifierLM158W,AWLM258W,AWLM358W,AWLOW POWER DUAL OPERATIONAL AMPLIFIERS■ INTERNALLY FREQUENCY COMPENSATED ..
LM358WN ,LOW POWER DUAL BIPOLAR OP-AMPSLM158W,AWLM258W,AWLM358W,AWLOW POWER DUAL OPERATIONAL AMPLIFIERS■ INTERNALLY FREQUENCY COMPENSATED ..
LM358WPT , SIGNATURE SERIES Operational Amplifiers
LM358Y ,DUAL OPERATIONAL AMPLIFIERSFeatures 2 Applications1• Wide Supply Ranges • Blu-ray Players and Home Theaters– Single Supply: 3 ..
LM3590MFX ,Series White LED DriverPin Description#Pin Name Function1I Programmable LED current Input. The LED current has the followi ..
LM3595LD ,Parallel White-LED DriverApplicationsness control to be disabled.Alternatively, a PWM signal cann Portable devices using whi ..
LMV324QPWG4 ,Quad Low-Voltage Rail-to-Rail Output Operational Amplifier 14-TSSOP -40 to 125Electrical Characteristics: V + = 2.7 V.. 5CC12.2 Trademarks..... 237.6
LMV324SIPWRG4 ,Quad, Low-Voltage, RRO with Shutdown 16-TSSOP -40 to 85
LMV331ICT ,General purpose low voltage comparatorAbsolute maximum ratingsSymbol Parameter Value Unit(1)V Supply voltage 5.5 VCCV Differential input ..
LMV331IDBVR ,Single General Purpose Low-Voltage ComparatorSample & Support &Product Tools &TechnicalCommunityBuyFolder Documents SoftwareLMV331, LMV393, LMV3 ..
LMV331IDBVRG4 ,Single General Purpose Low-Voltage Comparator 5-SOT-23 -40 to 125Maximum Ratings(1)over operating free-air temperature range (unless otherwise noted)MIN MAX UNIT(2) ..
LMV331IDBVT ,Single General Purpose Low-Voltage ComparatorMaximum Ratings from 5.5 V to V ...... 4I CC+Changes from Revision M (November 2005) to Revision N ..
LM358WD-LM358WDT-LM358WN
LOW POWER DUAL BIPOLAR OP-AMPS
INTERNALLY FREQUENCY COMPENSATED LARGE DC VOLTAGE GAIN: 100dB� WIDE BANDWIDTH (unity gain): 1.1MHz(temperature compensated) VERY LOW SUPPLY CURRENT/OP (500μA)
ESSENTIALLY INDEPENDENT OF SUPPLY
VOLTAGE� LOW INPUT BIAS CURRENT: 20nA
(temperature compensated)� LOW INPUT OFFSET VOLTAGE: 2mV LOW INPUT OFFSET CURRENT: 2nA� INPUT COMMON-MODE VOLTAGE RANGE
INCLUDES GROUND DIFFERENTIAL INPUT VOLTAGE RANGE
EQUAL TO THE POWER SUPPLY VOLTAGE LARGE OUTPUT VOLTAGE SWING 0V TO
(Vcc - 1.5V) � ESD INTERNAL PROTECTION : 2KV
DESCRIPTIONThese circuits consist of two independent, high
gain, internally frequency compensated which
were designed specifically to operate from a sin-
gle power supply over a wide range of voltages.
The low power supply drain is independent of the
magnitude of the power supply voltage.
Application areas include transducer amplifiers,
dc gain blocks and all the conventional op-amp
circuits which now can be more easily implement-
ed in single power supply systems. For example,
these circuits can be directly supplied with the
standard +5V which is used in logic systems and
will easily provide the required interface electron-
ics without requiring any additional power supply.
Inthe linear mode the input common-mode voltage
range includes ground and the output voltage can
also swing to ground, even though operated from
only a single power supply voltage.
ORDER CODE
N = Dual in Line Package (DIP)
D = Small Outline Package (SO) - also available in Tape & Reel (DT)S = Small Outline Package (miniSO) - also available in Tape & Reel (DT)
P = Thin Shrink Small Outline Package (TSSOP) - only available in Tape &Reel (PT)
PIN CONNECTIONS (top view)
LM158W,AW
LM258W,AWLOW POWER DUAL OPERATIONAL AMPLIFIERS
LM158W-AW, LM258W-AW, LM358W-AW
SCHEMATIC DIAGRAM (1/2 LM158W)
ABSOLUTE MAXIMUM RATINGS Short-circuits from the output to VCC can cause excessive heating if VCC > 15V. The maximum output current is approximately 40mA independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short-circuit on all amplifiers. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of the input PNP
transistor becoming forward biased and thereby acting as input diodes clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. this transistor action can cause the output voltages of the Op-amps to go to the VCC voltage level (or to ground for a large overdrive) for the time duration than an input is driven negative.
This is not destructive and normal output will set up again for input voltage higher than -0.3V.
LM158W-AW, LM258W-AW, LM358W-AW
ELECTRICAL CHARACTERISTICSVCC+ = +5V, VCC- = Ground, Vo = 1.4V, Tamb = +25°C (unless otherwise specified)
LM158W-AW, LM258W-AW, LM358W-AW
Vo = 1.4V, Rs = 0Ω, 5V < VCC+ < 30V, 0 < Vic < VCC+ - 1.5V The direction of the input current is out of the IC. This current is essentially constant, independent of the state of the output so no loading change exists on the input lines. The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the common-mode voltage range is VCC+ - 1.5V, but either or both inputs can go to +32V without damage. Due to the proximity of external components insure that coupling is not originating via stray capacitance between these external parts. This typically
can be detected as this type of capacitance increases at higher frequences.
LM158W-AW, LM258W-AW, LM358W-AW
LM158W-AW, LM258W-AW, LM358W-AW
