LD1117DT33TR ,LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORSElectrical Characteristics Of LD1117#25 (refer to the test circuits, T = 0 to 125°C,JC = 10 µF unle ..
LD1117DT50 ,LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORSBLOCK DIAGRAMFebruary 2003 1/23LD1117 SERIES
LD1117DT50CTR ,LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORSLD1117SERIESLOW DROP FIXED AND ADJUSTABLEPOSITIVE VOLTAGE REGULATORS
LD1117D33CTR-LD1117D33TR-LD1117DT12TR-LD1117DT18CTR-LD1117DT18TR-LD1117DT25CTR-LD1117DT25C-TR-LD1117DT25TR-LD1117DT25-TR-LD1117DT28-TR-LD1117DT-3.3TR-LD1117DT30TR-LD1117DT33CTR-LD1117DT33TR-LD1117DT50CTR-LD1117DT50TR-LD1117DT50-TR-LD1117DTC-R-LD1117DTR-LD1117DTTR
LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORS
1/28October 2004 LOW DROPOUT VOLTAGE (1V TYP.) 2.85V DEVICE PERFORMANCES ARE
SUITABLE FOR SCSI-2 ACTIVE
TERMINATION OUTPUT CURRENT UP TO 800 mA FIXED OUTPUT VOLTAGE OF: 1.2V, 1.8V,
2.5V, 2.85V, 3.0V, 3.3V, 5.0V ADJUSTABLE VERSION AVAILABILITY
(Vrel=1.25V) INTERNAL CURRENT AND THERMAL LIMIT AVAILABLE IN ± 1% (AT 25°C) AND 2% IN
FULL TEMPERATURE RANGE SUPPLY VOLTAGE REJECTION: 75dB (TYP.)
DESCRIPTION The LD1117 is a LOW DROP Voltage Regulator
able to provide up to 800mA of Output Current,
available even in adjustable version (Vref=1.25V).
Concerning fixed versions, are offered the
following Output Voltages: 1.2V,1.8V,2.5V,2.85V,
3.0V 3.3V and 5.0V. The 2.85V type is ideal for
SCSI-2 lines active termination. The device is
supplied in: SOT-223, DPAK, SO-8, TO-220 and
TO-220FM. The SOT-223 and DPAK surface
mount packages optimize the thermal
characteristics even offering a relevant space
saving effect. High efficiency is assured by NPN
pass transistor. In fact in this case, unlike than
PNP one, the Quiescent Current flows mostly into
the load. Only a very common 10µF minimum
capacitor is needed for stability. On chip trimming
allows the regulator to reach a very tight output
voltage tolerance, within ± 1% at 25°C. The
ADJUSTABLE LD1117 is pin to pin compatible
with the other standard. Adjustable voltage
regulators maintaining the better performances in
terms of Drop and Tolerance.
LD1117
SERIESLOW DROP FIXED AND ADJUSTABLE
POSITIVE VOLTAGE REGULATORS
Figure 1: Block DiagramRev. 16
LD1117 SERIES2/28
Figure 2: Pin Connection (top view) NOTE: The TAB is connected to the VOUT.
Table 1: Order Codes (*) Available on request
LD1117 SERIES3/28
Table 2: Absolute Maximum Ratings Absolute Maximum Ratings are those values beyond which damage to the device may occur. Functional operation under these condition is
not implied. Over the above suggested Max Power Dissipation a Short Circuit could definitively damage the device.
Table 3: Thermal Data
Figure 3: Application Circuit (FOR 1.2 V)
Figure 4: Application Circuit (FOR OTHER FIXED OUTPUT VOLTAGES)
LD1117 SERIES4/28
Table 4: Electrical Characteristics Of LD1117#12 (refer to the test circuits, TJ = 0 to 125°C,O = 10 µF, R = 120 Ω between GND and OUT pins, unless otherwise specified)
Table 5: Electrical Characteristics Of LD1117#18 (refer to the test circuits, TJ = 0 to 125°C,CO = 10 µF unless otherwise specified)
LD1117 SERIES
5/28
Table 6: Electrical Characteristics Of LD1117#25 (refer to the test circuits, TJ = 0 to 125°C,
CO = 10 µF unless otherwise specified)
Table 7: Electrical Characteristics Of LD1117#28 (refer to the test circuits, TJ = 0 to 125°C,
CO = 10 µF unless otherwise specified)
LD1117 SERIES
6/28
Table 8: Electrical Characteristics Of LD1117#30 (refer to the test circuits, TJ = 0 to 125°C,O = 10 µF unless otherwise specified)
Table 9: Electrical Characteristics Of LD1117#33 (refer to the test circuits, TJ = 0 to 125°C,
CO = 10 µF unless otherwise specified)
LD1117 SERIES
7/28
Table 10: Electrical Characteristics Of LD1117#50 (refer to the test circuits, TJ = 0 to 125°C,O = 10 µF unless otherwise specified)
Table 11: Electrical Characteristics Of LD1117 (ADJUSTABLE) (refer to the test circuits,J = 0 to 125°C, CO = 10 µF unless otherwise specified)
LD1117 SERIES
8/28
Table 12: Electrical Characteristics Of LD1117#12C (refer to the test circuits, TJ = 0 to 125°C,O = 10 µF, R = 120 Ω between GND and OUT pins, unless otherwise specified)
LD1117 SERIES
9/28
Table 13: Electrical Characteristics Of LD1117#18C (refer to the test circuits, TJ = -40 to 125°C,O = 10 µF unless otherwise specified)
LD1117 SERIES
10/28
Table 14: Electrical Characteristics Of LD1117#25C (refer to the test circuits, TJ = -40 to 125°C,O = 10 µF unless otherwise specified)
LD1117 SERIES
11/28
Table 15: Electrical Characteristics Of LD1117#30C (refer to the test circuits, TJ = -40 to 125°C,O = 10 µF unless otherwise specified)
LD1117 SERIES
12/28
Table 16: Electrical Characteristics Of LD1117#33C (refer to the test circuits, TJ = -40 to 125°C,O = 10 µF unless otherwise specified)
LD1117 SERIES
13/28
Table 17: Electrical Characteristics Of LD1117#50C (refer to the test circuits, TJ = -40 to 125°C,O = 10 µF unless otherwise specified)
LD1117 SERIES
14/28
Table 18: Electrical Characteristics Of LD1117C (ADJUSTABLE) (refer to the test circuits,J = -40 to 125°C, CO = 10 µF unless otherwise specified)
TYPICAL APPLICATIONS
Figure 5: Negative Supply
