JM38510/11703SXA ,3-Terminal Adjustable RegulatorGeneral DescriptionThe LM117 adjustable 3-terminal positive voltage regulator is capable of supplyi ..
JM38510/11704SYA ,3-Terminal Adjustable Regulatorapplications. Since the regulator is "Floating" and sees only the input-to-outputdifferential volta ..
JM38510/11905BPA ,Low Offset, Low Drift Dual JFET Input Operational AmplifierLF412 Low Offset, Low Drift Dual JFET Input Operational AmplifierAugust 2000LF412Low Offset, Low Dr ..
JM38510/11906BCA ,Wide Bandwidth Quad JFET Input Operational Amplifiersapplications such as high speed integrators, fast D/A converters,sample-and-hold circuits and many ..
JM38510/12501BGA ,Monolithic Sample and Hold CircuitGeneral DescriptionThe LF198 is a monolithic sample-and-hold circuit which utilize BI-FET technolog ..
JM38510/12902BPA ,Dual Very-High Speed, High-Current Peripheral DriversLogic Diagram...... 1Changes from Revision B (January 1999) to Revision C Page• Added ESD Ratings t ..
KA22234 , 5 BAND DUAL GRAPHIC EQ AMP
KA22234 , 5 BAND DUAL GRAPHIC EQ AMP
KA22234 , 5 BAND DUAL GRAPHIC EQ AMP
KA2225 , DUAL PREAMPLIFIER FOR 3V USING
KA224 ,Quad Operational AmplifierFeatures Description• Internally Frequency Compensated for Unity Gain The KA324 series consist of f ..
KA224 ,Quad Operational AmplifierBlock DiagramOUT1 14 OUT41IN4 (-)IN1 (-)2 131 4_ _+ +IN1 (+)IN4 (+)3 12VCC 114 GND_ _IN2 (+)5 10+ I ..
JM38510/11703SXA-LM117H/883
3-Terminal Adjustable Regulator
Original Creation Date: 10/19/99
Last Update Date: 09/10/02
Last Major Revision Date: 08/14/02
MRLM117-K-RH REV 3A0
MICROCIRCUIT DATA SHEET
POSITIVE THREE TERMINAL ADJUSTABLE VOLTAGE REGULATOR
GUARANTEED TO 100K RAD(Si) TESTED TO MIL-STD-883,
METHOD 1019.5, CONDITION A
General DescriptionThe LM117 adjustable 3-terminal positive voltage regulator is capable of supplying in
excess of 1.5A over a 1.2V to 37V output range. It is exceptionally easy to use and
requires only two external resistors to set the output voltage. Further, both line and
load regulation are better than standard fixed regulators.
In addition to higher performance than fixed regulators, the LM117 offers full overload
protection available only in IC's. Included on the chip are current limit, thermal
overload protection and safe area protection. All overload protection circuitry remains
fully functional even if the adjustment terminal is disconnected.
Normally, no capacitors are needed unless the device is situated more than 6 inches from
the input filter capacitors in which case an input bypass is needed. An optional output
capacitor can be added to improve transient response. The adjustment terminal can be
bypassed to achieve very high ripple rejection ratios which are difficult to achieve with
standard 3-terminal regulators.
Besides replacing fixed regulators, the LM117 is useful in a wide variety of other
applications. Since the regulator is "Floating" and sees only the input-to-output
differential voltage, supplies of several hundred volts can be regulated as long as the
maximum input to output differential is not exceeded, (i.e., avoid short-circuiting the
output).
Also, it makes an especially simple adjustable switching regulator, a programmable output
regulator, or by connecting a fixed resistor between the adjustment pin and output, the
LM117 can be used as a precision current regulator. Supplies with electronic shutdown can
be achieved by clamping the adjustment terminal to ground which programs the output to
1.2V where most loads draw little current.
For the negative complement, see LM137 data sheet.
