SN55115J. ,Dual Differential Line Receivermaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
SN55116J ,Differential Line Transreceiverfeatures a differential-input circuit having a common-mode voltage rangeof ±15 V. An internal 130-Ω ..
SN55183J ,Dual Differential Line Driver DS8830, SN55183, SN75183 DUAL DIFFERENTIAL LINE DRIVERS SLLS093D – OCTOBER 1972 – REVISED APRIL 19 ..
SN55188J ,Quadruple Line Driver SLLS094C − SEPTEMBER 1983 − REVISED MAY 2004SN55188 ... ..
SN55189AJ ,Quadruple Line Receivermaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
SN55451 , DUAL PERIPHERAL DRIVERS
SN74HC174D , Wide Operating Voltage Range of 2 V to 6 V, Outputs Can Drive Up To 10 LSTTL Loads
SN74HC175NSR , QUADRUPLE D-TYPE FLIP-FLOPS WITH CLEAR
SN74HC175NSR , QUADRUPLE D-TYPE FLIP-FLOPS WITH CLEAR
SN74HC175PWR , QUADRUPLE D-TYPE FLIP-FLOPS WITH CLEAR
SN74HC191D , 4-BIT SYNCHRONOUS UP/DOWN BINARY COUNTERS
SN74HC191NSR , 4-BIT SYNCHRONOUS UP/DOWN BINARY COUNTERS
JM38510/10404BEA-SN55115J-SN55115J.-SNJ55115FK-SNJ55115J-SNJ55115J.
Dual Differential Line Receiver
Dual-Channel Operation TTL Compatible ±
15-V Common-Mode Input Voltage Range Optional-Use Built-In 130-Ω Line-Terminating Resistor Individual Frequency-Response Controls Individual Channel Strobes Designed for Use With SN55113, SN75113,
SN55114, and SN75114 Drivers Designed to Be Interchangeable With
National DS9615 Line Receivers
descriptionThe SN55115 and SN75115 dual differential line
receivers are designed to sense small differential
signals in the presence of large common-mode
noise. These devices give TTL-compatible output
signals as a function of the differential input
voltage. The open-collector output configuration
permits the wire-ANDing of similar TTL outputs
(such as SN5401/SN7401) or other
SN55115/SN75115 line receivers. This permits a
level of logic to be implemented without extra
delay.
The output stages are similar to TTL totem-pole outputs, but with sink outputs, 1YS and 2YS, and the
corresponding active pullup terminals, 1YP and 2YP, available on adjacent package pins. The frequency
response and noise immunity may be provided by a single external capacitor. A strobe input is provided for each
channel. With the strobe in the low level, the receiver is disabled and the outputs are forced to a high level.
The SN55115 is characterized for operation over the full military temperature range of –55°C to 125°C. The
SN75115 is characterized for operation from 0°C to 70°C.
FUNCTION TABLEH = VI ≥ VIH min or VID more positive than VT+ max
L = VI ≤ VIL max or VID more negative thanVT– max
X = irrelevant
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
1STRB
1RTC
1RT
GND
2YP
2STRB
2RTCT
2YP
2STRB
2RTC
1STRB
1RTC
1RT
SN55114... FK PACKAGE
(TOP VIEW)1YP1YSNC 2YS
GND
NC – No internal connection
