IRIS4015 ,180W Output AC-DC Integrated Switchers in a TO-220 (5-Leads) packageFeaturesPackages• Primary current mode control, and secondaryvoltage mode control•Vcc Over-voltage ..
IRIS-A6359 , INTEGRATED SWITCHER
IRKH105/08 ,800V 105A Doubler Circuit Positive Phase Control Thyristor/Diode in a ADD-A-Pak packageFeatures BenefitsHigh VoltageUp to 1600VIndustrial Standard Package Full compatible TO-240AA105 ATh ..
IRKH136-08 ,800V 135A Doubler Circuit Positive Phase Control Thyristor/Diode in a INT-A-Pak packageApplicationsDC Motor Control and DrivesBattery ChargesWeldersPower ConvertersLighting ControlHeat a ..
IRKH162-16 ,1600V 160A Doubler Circuit Positive Phase Control Thyristor/Diode in a INT-A-Pak packageBulletin I27117 rev. C 03/02SERIES IRK.136, .142, .162THYRISTOR/DIODE and NEW INT-A-pak Power ..
IRKH26/12 ,1200V 27A Doubler Circuit Positive Phase Control Thyristor/Diode in a ADD-A-Pak packageFeatures BenefitsHigh VoltageUp to 1600VIndustrial Standard Package Full compatible TO-240AA27 AThi ..
ISP1362EE/01 ,ISP1362; Single-chip Universal Serial Bus On-The-Go controller
ISP1505ABS , ULPI Hi-Speed USB host and peripheral transceiver
ISP1505ABS , ULPI Hi-Speed USB host and peripheral transceiver
ISP1507DBS , ULPI Hi-Speed Universal Serial Bus host and peripheral transceiver
ISP1563BM ,Hi-Speed Universal Serial Bus PCI Host Controller
ISP1563BM ,Hi-Speed Universal Serial Bus PCI Host Controller
IRIS4015
180W Output AC-DC Integrated Switchers in a TO-220 (5-Leads) package
International
TCdl Rectifier
Data SheetNo. PD60190-C
|R|S4015(K)
Features
q Primary current mode control, and secondary
voltage mode control
q Vcc Over-voltage protection (latched)
q Over-current & over-temperature protection
q Quasi resonant, variable frequency operation
q 5 pin TO-220 and TO-262 package
q 0.979 Rds(on) max/ 650V MOSFET
. Fully Characterized Avalanche Energy
Descriptions
INTEGRATED SWITCHER
Packages
IRIS4015 IRlS4015K
5 Lead TO-220 5 Lead TO-262
The |R|S4015(K) is a dual mode voltage and current controller combined with a MOSFET in a single package.
The |R|S4015(K) is designed for use in AC/DC switching power supplies up to 230VAC nominal input, and is
capable of 1 80W for a universal line input.The device operates on a quasi-resonant or Pulse Ratio Control (PRC)
basis, and thereby variable frequency operation.
Typical Connection Diagram
(AC/ H
7 = I T
o Vout
d,, ji J
IRIS4015(K)
Source Gnd
_H__°'
(Refer to Lead Assignments for correct pin
connguration). This/These diagram(s) show electrical
connections only. Please refer to our DesignTips
and Application Notes (AN1018a, AN1024a,
AN1025) for proper circuit board layout.
|R|S4015(K)
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters are
absolute voltages referenced to terminals stated, all currents are dermed positive into any lead. The thermal resistance and
power dissipation ratings are measured under board mounted and still air conditions.
International
TOR Rectifier
Symbol Definition Terminals Max. Ratings Units Note
IDpeak Peak drain current 3-1 21 Single pulse
leax Maximum switching current 3-1 8 A V2.3 = 0.78V
Ta=-20 - +125°C
EAs Single pulse avalanche energy 3-1 325 mJ single pulse
ILpeak=5.7A
Vcc Power supply voltage 4-3 35 V
VTH OCP/FB terminal voltage 5-2 6
P01 Power dissipation tor MOSFET 3-1 235 \Mth infinite heatsink
1.2 W 1luthout heatsink
P02 Powerdissipation tor control part (MIC) 4-2 0.8 Specified by VIN x IIN
RthJc Thermal resistance, junction to case - 0.53 °CNV
TJ Junction temperature - M0-125
Ts Storage temperature - M0-125
Tf Internal frame temperature in operation - -20-125 ( Referto recommended
operating temperature
Top Ambient operating temperature - -20-125
TL Lead temp. (soldering, 10 seconds) - 300
Recommended Operating Conditions
Time for input of quasi resonant signals.
For the Quasi resonant signal inputted to the Vocp/FB
terminal at the time ofquasi resonant operation, the
signal should be wider thantTth(2)
VOCP/F B
