IRIS4011 ,60W Output AC-DC Integrated Switchers in a TO-220 (5-Leads) packageFeatures• Primary current mode control, and secondaryPackagesvoltage mode control• Vcc Over-voltage ..
IRIS4015 ,180W Output AC-DC Integrated Switchers in a TO-220 (5-Leads) packageFeaturesPackages• Primary current mode control, and secondaryvoltage mode control•Vcc Over-voltage ..
IRIS-A6359 , INTEGRATED SWITCHER
IRKH105/08 ,800V 105A Doubler Circuit Positive Phase Control Thyristor/Diode in a ADD-A-Pak packageFeatures BenefitsHigh VoltageUp to 1600VIndustrial Standard Package Full compatible TO-240AA105 ATh ..
IRKH136-08 ,800V 135A Doubler Circuit Positive Phase Control Thyristor/Diode in a INT-A-Pak packageApplicationsDC Motor Control and DrivesBattery ChargesWeldersPower ConvertersLighting ControlHeat a ..
IRKH162-16 ,1600V 160A Doubler Circuit Positive Phase Control Thyristor/Diode in a INT-A-Pak packageBulletin I27117 rev. C 03/02SERIES IRK.136, .142, .162THYRISTOR/DIODE and NEW INT-A-pak Power ..
ISP1362 ,Single-chip Universal Serial Bus On-The-Go controller
ISP1362EE/01 ,ISP1362; Single-chip Universal Serial Bus On-The-Go controller
ISP1505ABS , ULPI Hi-Speed USB host and peripheral transceiver
ISP1505ABS , ULPI Hi-Speed USB host and peripheral transceiver
ISP1507DBS , ULPI Hi-Speed Universal Serial Bus host and peripheral transceiver
ISP1563BM ,Hi-Speed Universal Serial Bus PCI Host Controller
IRIS4011
60W Output AC-DC Integrated Switchers in a TO-220 (5-Leads) package
International
TGiR Rectifier
Data SheetNo. PD60188-B
|R|S4011(K)
Features
q Primary current mode control, and secondary
voltage mode control
q Vcc Over-voltage protection (latched)
q Over-current & over-temperature protection
q Quasi resonant, variable frequency operation
q 5 pin TO-220 and TO-262
q 3.99 Rds(on) max/ 650V MOSFET
q Fully Characterized Avalanche Energy
Description
INTEGRATED SWITCHER
Packages
|R|S4011 lRlS4011K
5 Lead TO-220 5 Lead TO-262
The |R|S4011(K) is a dual mode voltage and current controller combined with a MOSFET in a single package.
The |R|S4011(K) is designed for use in universal and single input AC/DC and DC/DC switching power supplies
and is capable of powers up to 60W for a universal line input.The device can operate in either a quasi-resonant or
Pulse Ratio Control (PRC) mode, and thereby variable frequency operation.
Typical Connection Diagram
(AC/ a
o Vout
o,1,,, 4% J
IRIS4011(K)
Source Gnd
_4 §_e
(Refer to Lead Assignments for correct pin
configuration). This/These diagram(s) show
electrical connections only. Please refer to our
DesignTips and Application Notes (AN1018a,
AN1024a, AN1025) for proper circuit board
layout.
IRIS4011(K)
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters are
absolute voltages referenced to terminals stated, all currents are dermed positive into any lead. The thermal resistance and
power dissipation ratings are measured under board mounted and still air conditions.
International
TOR Rectifier
Symbol Definition Terminals Max. Ratings Units Note
IDpeak Peak drain current 3-1 6.8 Single pulse
leax Maximum switching current 3-1 2.7 A V2-3 = 0.78V
Tc=25°C
EAS Single pulse avalanche energy 3-1 92 mJ Vdd=99V,L=20mH,
G=12V, |pk=2.8A
Vcc Power supply voltage 4-3 35 V
VTH OCP/FB terminal voltage 5-2 6
P01 Power dissipation tor MOSFET 3-1 89 \Mth infinite heatsink
1.4 W VWhout heatsink
P02 Power dissipation tor control part (MIC) 4-2 0.8 Specified by VIN x IIN
RthJc Thermal resistance, junction to case - 1.4 °CNV
TJ Junction temperature - M0-125
Ts Storage temperature - M0-125
Tf Internal frame temperature in operation - -20-125 ( Referto recommended
operating temperature
TOP Ambient operating temperature - -20-125
TL Lead temp. (soldering, 10 seconds) - 300
Recommended Operating Conditions
Time for input of quasi resonant signals.
For the Quasi resonant signal inputted to the Vncp/FB
terminal at the time ofquasi resonant operation, the
signal should be wider thantTth(2)
VOCP/FB
Ttht2l21.0gs .
Vth(2)
