ILC6383CIR33 ,1-Cell to 3-Cell Boost DC-DC Converter with True Load Disconnect, 3.3V, 5V or Adjustable OutputApplicationsCIN ILC6383-XX ILC6383-ADJCINLL47µ F47µ F++VOUT1 LX 8 VOUTVOUT 1 8 VOUTLX+47µ F +COUT15 ..
ILC6383CIR33X ,1-Cell to 3-Cell DC/DC Boost Converter with True Load DisconnectApplications Information” section.6 LBO This open drain output will go low if the battery voltage i ..
ILC6383CIR33X ,1-Cell to 3-Cell DC/DC Boost Converter with True Load DisconnectElectrical Characteristics ILC6383CIR-33 in PWM Mode (SEL Open)Unless otherwise specified, all limit ..
ILC6383CIR50X ,1-Cell to 3-Cell DC/DC Boost Converter with True Load DisconnectElectrical Characteristics ILC6383CIR-33 in PFM Mode (SEL in LOW State)Unless otherwise specified, a ..
ILC6383CIRADJ ,1-Cell to 3-Cell Boost DC-DC Converter with True Load Disconnect, 3.3V, 5V or Adjustable OutputApplicationsCIN ILC6383-XX ILC6383-ADJCINLL47µ F47µ F++VOUT1 LX 8 VOUTVOUT 1 8 VOUTLX+47µ F +COUT15 ..
ILC6383CIR-ADJ ,1-Cell to 3-Cell Boost DC-DC Converter with True Load Disconnect, 3.3V, 5V or Adjustable OutputApplications Information” section.6 LBO This open drain output will go low if the battery voltage i ..
IRF624S ,250V Single N-Channel HEXFET Power MOSFET in a D2-Pak packageapplications because of its low internal connection
resistance and can dissipate up to 2.0W in a t ..
IRF630 ,9A, 200V, 0.400 Ohm, N-Channel Power MOSFETsIRF630IRF630FPN-CHANNEL 200V - 0.35Ω - 9A TO-220/TO-220FPMESH OVERLAY™ MOSFETTYPE V R IDSS DS(on) D ..
IRF630A ,Advanced Power MOSFETIRF630AAdvanced Power MOSFET
IRF630B ,200V N-Channel MOSFETIRF630B/IRFS630BOctober 2001IRF630B/IRFS630B200V N-Channel MOSFET
IRF630F. , N-channel mosfet transistor
IRF630FI , N-CHANNEL ENHANCEMENT MODE POWER MOS TRANSISTOR
ILC6383CIR33
1-Cell to 3-Cell Boost DC-DC Converter with True Load Disconnect, 3.3V, 5V or Adjustable Output
Features Guaranteed start up in PWM at 0.9V input Synchronous rectification requires no external diode True load disconnect from battery input in shutdown Up to 75mA at 3.3V and 40mA at 5V from 1V input Up to 375mA at 3.3V and 300mA at 5V from 3V input Peak efficiency > 90% 1µA battery input current in shutdown (with V
OUT
= 0V) Internal Oscillator frequency: 300kHz to ±15% ILC6383: Fixed 3.3V or 5V output ILC6383-ADJ: Adjustable output to 6V maximum Low battery detector with 100ms transient rejection delay Powergood output flag when V
OUT
is in regulation
Applications Cellular Phones, Pagers Palmtops, PDAs and portable electronics High efficiency 1V step up converters
DescriptionThe ILC6383 series of step-up DC-DC converters operate
from 1-cell to 3-cell input. They are direct replacement for
ILC6382, in applications where SYNC pin is not used. The
PFM or PWM operating mode is user selectable through
SEL pin connected to ground or left open, respectively. The
choice should be dependent upon the current to be delivered
to the load: PFM is recommended for input voltage higher
than 1.5V and loads below 100mA, while PWM is recom-
mended for more than 50mA load current and in noise sensi-
tive applications. In shutdown mode, the device allows true
load disconnect from battery input. Designed for wireless
communications applications, the oscillator frequency is set
at 300kHz with no harmonics at sub 20kHz audio band or at
455kHz IF band.
Internal synchronous rectification and externally selectable
PFM/PWM mode of operation allows the selection of the
best efficiency at light or full load. The ILC6383 is capable
of delivering 75mA at 3.3V output from a single cell input.
The ILC6383-XX offers 3.3V or 5V fixed output voltage
while the ILC6383-ADJ allows adjustable output voltage to
6V maximum. Output voltage accuracy is ±3.5% over full
operating temperature range.
Additional features include power good output (POK) and an
internal low battery detector with 100ms transient rejection
delay. The device will reject low battery input transients
under 100ms in duration. The ILC6383 series is available in
a space saving eight lead micro SOP (MSOP-8) package.
Typical Applications
