DS9098P-TRL ,iButton RetainerDS9098PiButton Retainer www.dalsemi.com19.30
DS90C031BTM ,LVDS Quad CMOS Differential Line Driverapplications requiring ultra low power dissipa- n High impedance LVDS outputs with power-offtion an ..
DS90C031BTMX ,LVDS Quad CMOS Differential Line DriverFeatures>n 155.5 Mbps (77.7 MHz) switching ratesThe DS90C031B is a quad CMOS differential line driv ..
DS90C031BTMX ,LVDS Quad CMOS Differential Line Driverapplications.Connection Diagram Functional DiagramDual-In-Line10098901Order Number DS90C031BTMSee N ..
DS90C031BTMX ,LVDS Quad CMOS Differential Line DriverElectrical CharacteristicsOver supply voltage and operating temperature ranges, unless otherwise sp ..
DS90C031BTWM ,LVDS Quad CMOS Differential Line DriverElectrical CharacteristicsOver supply voltage and operating temperature ranges, unless otherwise sp ..
DS9098P-TRL
iButton Retainer
DS9098P
iButton Retainer
FEATURESCompact receptacle for F5 iButton mountingFully backward-compatible to DS9098Contacts are stainless steel with selective tin-
lead plating for optimal solderability to
printed circuit boardRetainer to iButton connection is stainless
steel to stainless steelWithstands up to 250°C for surface mountingDouble redundancy of contacts (2 plus 2)Contact force exceeds 200 grams for reliable
connectionPrevents reversed insertionAt insertion, the iButton is latched for reten-
tionThe iButton pops up for removal when latch
is releasedGentle deflection of latches allows removal of
the iButton>25 insertion/withdrawal cycles with no per-
formance degradationCompatible with standard pick and place
equipmentCleaning fluids drain freely for quick clean up
ORDERING INFORMATIONDS9098P-TRLTape & Reel, 220 parts per
13 inch reel
DESCRIPTIONThe DS9098P iButton Retainer is a low-cost, surface-mount device to secure an F5 iButton on a printed
circuit board. It consists of three metal pieces (two for GROUND, one for DATA) molded into a body of
black, heat-stabilized, 30% glass fiber reinforced Nylon 46.
When inserting an iButton into the DS9098P, closely align axis of the iButton and the retainer. The
retainer then latches the flange of the iButton. At removal, limit deflection of retainer latches to just free
the iButton edge from retained state. Avoid applying excess force to latches.
The DS9098P is only available on tape & reel. The tape specifications match those of 68-lead PLCC
devices except for the deeper pockets and tape-feed sprockets on either side of the 44 mm tape. Align-
This datasheet has been :
www.ic-phoenix.com
Datasheets for electronic components.
