CY74FCT2827CTQCT ,10-Bit Buffers/Drivers with 3-State Outputs and Series Damping Resistorsmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
CY74FCT373ATQCT ,Octal Transparent D-Type Latches with 3-State Outputsmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
CY74FCT373ATSOC ,Octal Transparent D-Type Latches with 3-State Outputslogic diagram (positive logic)1OE11LECP2Q O03DD0To Seven Other Channels2POST OFFICE BOX 655303 • DA ..
CY74FCT373CTSOC , 8-BIT LATCHES WITH 3-STATE OUTPUTS
CY74FCT373TSOC ,Octal Transparent D-Type Latches with 3-State OutputsCY54FCT373T, CY74FCT373T 8-BIT LATCHESWITH 3-STATE OUTPUTSSCCS021B – MAY 1994 – REVISED OCTOBER 20 ..
CY74FCT374ATPC ,Octal Transparent D-Type Latches with 3-State Outputsmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
D20LC20U , Super Fast Recovery Rectifiers(200V 20A)
D20LC20U , Super Fast Recovery Rectifiers(200V 20A)
D20XB80 , General Purpose Rectifiers(800V 20A)
D20XB80 , General Purpose Rectifiers(800V 20A)
D2212 , METAL GATE RF SILICON FET
D2213 , METAL GATE RF SILICON FET
CY74FCT2827ATQCT-CY74FCT2827CTQCT
10-Bit Buffers/Drivers with 3-State Outputs and Series Damping Resistors
OHof Equivalent FCT Functions Edge-Rate Control Circuitry for
Significantly Improved Noise
Characteristics Ioff Supports Partial-Power-Down Mode
Operation ESD Protection Exceeds JESD 22
– 2000-V Human-Body Model (A114-A)
– 200-V Machine Model (A115-A)
– 1000-V Charged-Device Model (C101) Matched Rise and Fall Times Fully Compatible With TTL Input and
Output Logic Levels 12-mA Output Sink Current
15-mA Output Source Current 3-State Outputs
descriptionThe CY74FCT2827T 10-bit buffer provides high-performance bus-interface buffering for wide data/address
paths or buses carrying parity. This 10-bit buffer has NANDed output-enable (OE) inputs for maximum control
flexibility. The CY74FCT2827T is designed for high-capacitance-load drive capability, while providing
low-capacitance bus loading at both inputs and outputs. All inputs have clamp diodes and all outputs are
designed for low-capacitance bus loading in the high-impedance state. On-chip termination resistors at the
outputs reduce system noise caused by reflections. The CY74FCT2827T can replace the CY74FCT827T to
reduce noise in an existing design.
This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs,
preventing damaging current backflow through the device when it is powered down.
ORDERING INFORMATION Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines
are available at www.ti.com/sc/package.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.147
GND147
OE2
