CLVC244AQPWRG4Q1 ,Automotive Catalog Octal Buffer/Driver With 3-State Outputs 20-TSSOP -40 to 125SN74LVC244A-Q1OCTAL BUFFER/DRIVERWITH 3-STATE OUTPUTSSCAS790B − DECEMBER 2004 − REVISED JANUARY 200 ..
CLVC540AQPWRG4Q1 ,Automotive Catalog Octal Buffer/Driver With 3-State Outputs 20-TSSOP -40 to 125features inputs andoutputs on opposite sides of the package that facilitate printed circuit board l ..
CLVC541AQPWRG4Q1 ,Automotive Catalog Octal Buffer/Driver With 3-State Outputs 20-TSSOP -40 to 125features inputs and outputs on opposite sides of the package to facilitate printed circuit board la ..
CLVCC3245AIDBREP ,Enhanced Product Octal Bus Transceiver With Adjustable Output Voltage And 3-State Outputs 24-SSOP -40 to 85maximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
CLVCC4245AMPWREP ,Enhanced Product Octal Dual-Supply Bus Transceiver W/Configurable Output Voltage And 3S Out 24-TSSOP -55 to 125FEATURESPW PACKAGE• Controlled Baseline(TOP VIEW)– One Assembly SiteV 1 24 VCCA CCB– One Test Site2 ..
CLVTH16244AQDLREP ,Enhanced Product 3.3-V Abt 16-Bit Buffer/Driver With 3-State Outputs 48-SSOP -40 to 125FEATURES• Controlled BaselineDGG, DGV, OR DL PACKAGE– One Assembly/Test Site, One Fabrication(TOP V ..
CR12AM , MEDIUM POWER USE NON-INSULATED TYPE, GLASS PASSIVATION TYPE
CR12BM , MEDIUM POWER USE NON-INSULATED TYPE, GLASS PASSIVATION TYPE
CR14-MQP/1GE ,ISO14443-B Reader ICFeatures■ Single 5 V ±500 mV supply voltage■ SO16N package■ Contactless communication16– ISO14443 t ..
CR14-MQP-1GE ,ISO14443-B Reader ICAbsolute maximum ratings . 35Table 9. I²C AC measurement conditions . . . . . 36Table 10. ..
CR14-MQTP/1GE ,ISO14443-B Reader ICCR14ISO14443 type-B contactless coupler chipwith anti-collision and CRC management
CR160 ,Diode Current Reg. 135V 1.76mA 2-Pin TO-206AAS-04234—Rev. D, 02-Jul-013-1CR160 SeriesVishay Siliconix Peak Operating Volta ..
CLVC244AQPWRG4Q1
Automotive Catalog Octal Buffer/Driver With 3-State Outputs 20-SOIC -40 to 125
−40°C to 125°C Max tpd of 5.9 ns at 3.3 V Typical VOLP (Output Ground Bounce)
<0.8 V at VCC = 3.3 V, TA = 25°C Typical VOHV (Output VOH Undershoot)
>2 V at VCC = 3.3 V, TA = 25°C Supports Mixed-Mode Signal Operation on
All Ports (5-V Input/Output Voltage With
3.3-V VCC) Ioff Supports Partial-Power-Down Mode
Operation Latch-Up Performance Exceeds 250 mA Per
JESD 17
description/ordering informationThis octal buffer/line driver is operational at 1.5-V to 3.6-V VCC, but is designed specifically for 1.65-V to 3.6-V
VCC operation.
The SN74LVC244A is organized as two 4-bit line drivers with separate output-enable (OE) inputs. When OE
is low, the device passes data from the A inputs to the Y outputs. When OE is high, the outputs are in the
high-impedance state.
Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of this device as a translator
in a mixed 3.3-V/5-V system environment.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for partial-power-down applications using Ioff . The Ioff circuitry disables the outputs,
preventing damaging current backflow through the device when it is powered down.
ORDERING INFORMATION† For the most current package and ordering information, see the Package Option Addendum at the end of this
document, or see the TI web site at www.ti.com. Package drawings, thermal data, and symbolization are available at www.ti.com/packaging.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
1OE
1A1
2Y4
1A2
2Y3
1A3
2Y2
1A4
2Y1
GND
VCC
2OE
1Y1
2A4
1Y2
2A3
1Y3
2A2
1Y4
2A1
DW OR PW PACKAGE
(TOP VIEW)
