AD8842AR ,8-Bit Octal, 4-Quadrant Multiplying, CMOS TrimDACSPECIFICATIONS(V = +5 V, V = –5 V, All V x = +3 V, T = –40°C to +85°C, unless otherwise noted.)ELEC ..
AD8842ARZ ,8-Bit Octal, 4-Quadrant Multiplying, CMOS TrimDACSpecifications subject to change without notice.–2– REV. 0AD88421SDI A3 A2 A1 A0 D7 D6 D5 D4 D3 D2 ..
AD890JP ,V(cc): +-7.5V; precision, wideband channel processing element. For high performance disk subsystem useSPECIFICATIONS (@ +2IPil and t5 y de, unless otherwise noted)
Parameter
Conditions
VARIABL ..
AD890JQ ,V(cc): +-7.5V; precision, wideband channel processing element. For high performance disk subsystem useSpecifications in boldface are tested on all production units at fiaal electrical test. Results fro ..
AD890JQ ,V(cc): +-7.5V; precision, wideband channel processing element. For high performance disk subsystem useFEATURES
An 80 MHz Bandwidth Permitting a so Mbls Data
Transfer Rate
A Variable Gain Amplifi ..
AD891JP ,RIGID DISK DATA CHANNEL QUALIFIERSPECIFICATIONS
Propagation Delay
20 mV Overdrive
200 mV Overdrive ns
Comparator Mismatch 30 ..
ADS5122CGHK ,Low Power, 8 Channel, 10-bit, 65MSPS ADC, 1.8VDC CHARACTERISTICSAV = DV = 1.8V, DRV = 3.3V, 50% Clock Duty Cycle, CLK = 40MSPS, Analog Input at – ..
ADS5122CZHK ,Low Power, 8 Channel, 10-bit, 65MSPS ADC, 1.8V 257-BGA MICROSTAR 0 to 70AC CHARACTERISTICSAV = DV = 1.8V, DRV = 3.3V, 50% Clock Duty Cycle, CLK = 65MSPS, Analog Input at – ..
ADS5122CZHK ,Low Power, 8 Channel, 10-bit, 65MSPS ADC, 1.8V 257-BGA MICROSTAR 0 to 70FEATURESThe ADS5122 is a low-power, 8-channel, 10-bit, 65MSPS* 8 DIFFERENTIAL ANALOG INPUTSCMOS Ana ..
ADS5203IPFBR ,10-Bit, 40MSPS ADC Dual Ch., Low Power
ADS5204IPFB ,10-Bit, 40MSPS ADC with PGA, Dual Ch., Low Power
ADS5204IPFBRG4Q1 ,Automotive Catalog Dual 10-Bit 40MSPS Low-Power ADC With PGA 48-TQFP -40 to 85FEATURES DESCRIPTIONThe ADS5204 is a dual 10-bit, 40 MSPS analog-to-digital Qualified for Automoti ..
AD8842AN-AD8842AR
8-Bit Octal, 4-Quadrant Multiplying, CMOS TrimDAC
AD8842–SPECIFICATIONS
ELECTRICAL CHARACTERISTICS
(VDD = +5 V, VSS = –5 V, All VINx = +3 V, TA = –40°C to +85°C, unless otherwise noted.)
Figure 3.Timing Diagram
ABSOLUTE MAXIMUM RATINGS(TA = +25°C unless otherwise noted)
VDD to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . .–0.3 V, +7 V
VSS to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . .+0.3 V, –7 V
VINx to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .VDD, VSS
VOUTx to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . .VDD, VSS
Short Circuit IOUTx to GND . . . . . . . . . . . . . . . . .Continuous
Digital Input & Output Voltage to GND . . . . . . . . . .VDD, 0 V
Operating Temperature Range . . . . . . . . . . . .–40°C to +85°C
Maximum Junction Temperature (TJ Max) . . . . . . . . .+150°C
Storage Temperature . . . . . . . . . . . . . . . . . . .–65°C to +150°C
Lead Temperature (Soldering, 10 sec) . . . . . . . . . . . .+300°C
Package Power Dissipation . . . . . . . . . . . . . . .(TJ Max–TA)/θJA
Thermal Resistance θJA,
SOIC (SOL-24) . . . . . . . . . . . . . . . . . . . . . . . . . . . .70°C/W
P-DIP (N-24) . . . . . . . . . . . . . . . . . . . . . . . . . . . . .57°C/W
ORDERING GUIDE*XIND = –40°C to +85°C. The AD8842 contains 2452 transistors.
CAUTIONESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000V readily
accumulate on the human body and test equipment and can discharge without detection.
Although the AD8842 features proprietary ESD protection circuitry, permanent damage may
occur on devices subjected to high energy electrostatic discharges. Therefore, proper ESD
precautions are recommended to avoid performance degradation or loss of functionality.
AD8842
PIN DESCRIPTION
PIN CONFIGURATION
Table I.Serial Input Decode Table
Table II.Input Logic Control Truth Table*Data shifted into the SDI pin appears twelve clocks later at the SDO pin.
AD8842–Typical Performance CharacteristicsFigure 4.Linearity Error vs.
Digital Code
Figure 5.Linearity Error vs.
Digital Code vs. Temperature
Figure 7.Input Resistance (VIN)
vs. Temperature
Figure 8.Total Harmonic Distortion
vs. Frequency
Figure 10.Gain and Phase vs.
Frequency (Code = 00H or FFH)
Figure 11.DAC Crosstalk
vs. Frequency
