7703401YA ,Hi-Rel Adjustable Voltage 3-Terminal Positive RegulatorELECTRICAL CHARACTERISTICS -55°C ≤ T ≤ 125°C, I = 8mA (unless otherwise specified)A LOM1320N2M ..
7704301CA ,Quad General-Purpose Operational Amplifier SLOS066W–SEPTEMBER 1975–REVISED MARCH 20155 Pin Configuration and FunctionsFK PackageD, DB, J, N, ..
7705201EC , Single 8-Ch/Differential 4-Ch CMOS Analog Multiplexers
7705201EC , Single 8-Ch/Differential 4-Ch CMOS Analog Multiplexers
7705701RA ,Octal Buffers And Line Drivers With 3-State OutputsMaximum Ratings.. 410 Power Supply Recommendations... 176.2 ESD Ratings........ 411 Layout.... 176. ..
7705AI , SUPPLY-VOLTAGE SUPERVISORS
8ETH03 ,300V 8A Ultra-Fast Discrete Diode in a TO-220AC packageApplicationsInternational Rectifier's 300V series are the state of the art Ultrafast recovery rect ..
8ETH03-1 ,300V 8A Ultra-Fast Discrete Diode in a TO-262 packageFeaturest = 35nsrr • Ultrafast Recovery TimeI = 8Amp• Low Forward Voltage DropF(AV)• Low Leak ..
8ETH03S ,300V 8A Ultra-Fast Discrete Diode in a D2-Pak (UltraFast) packageBulletin PD-20023 rev. C 09/018ETH038ETH03S8ETH03-1Ultrafast Rectifier
8ETH06 ,600V 8A HyperFast Discrete Diode in a TO-220AC packageFeatures• Hyperfast Recovery Timet = 18ns typ.rr • Low Forward Voltage Drop• Low Leakage Cur ..
8ETH06FP ,600V 8A Hyperfast Discrete Diode in a TO-220 FullPack packageFeatures• Hyperfast Recovery Timet = 18ns typ.rr • Low Forward Voltage Drop• Low Leakage Cur ..
8ETH06PBF , Hyperfast Rectifier, 8 A FRED PtTM
7703401YA
Hi-Rel Adjustable Voltage 3-Terminal Positive Regulator
OM1320SMM OM1320NMM OM1320STM
OM1320NKM OM1320NTM OM1320N2M
1.5 AMP POSITIVE ADJUSTABLE VOLTAGE
REGULATOR APPROVED TO DESC DRAWING 7703401
--((iib)-- 'iihaMrimifhriflmcaftftim2asitiil%
:i,(2/- fRGfiftnRtdltigpmpgrftitiai'fliyflflcaiiiMhs
Please see mechanical
outlines herein
(jmtimrflrigpim(Wi!flim)
411 R2
Supersedes1 07 R1 3.5 - 1
FEATURES
. Similar To Industry Standard LM117
. Approved To DESC Standardized Military Drawing Number 7703401
. Built In Thermal Overload Protection
. Short Circuit Current Limiting
. Available In Six Package Styles
DESCRIPTION
These three terminal positive regulators are supplied in hermetically sealed
packages. All protective features are designed into the circuit, including thermal
shutdown, current-limiting, and safe-area control. With heat sinking, these devices
can deliver up to 1.5 amps of output current. The LCC-20 device is limited to .5
amps. The unit also features output voltages that can be fixed from 1.2 volts to 37
volts using external resistors.
ABSOLUTE MAXIMUM RATINGS Tc @ 25°C
Power Dissipation
Case 2 _..................................................... 1.1 W
Case-All Others ............................................... 20 W
Input - Output Voltage Differential .................................... 40 V
Operating Junction Temperature Range ..................... - 55''C to + 150°C
Storage Temperature Range .............................. - 65°C to + 150°C
Lead Temperature (Soldering 10 seconds) ........................... 300°C
Thermal Resistance, Junction to Case:
Case 2, LCC-20 ............................................. 17°CNV
Case U & M, TO-257 (Isol) and SMD-3 .......................... 4.2°CNV
Case T&N, TO-257 (Non-lsol) and SMD-1 ....................... 3.5°CNV
Case Y, TO- ............................................ 3.0°CNV
Maximum Output Current:
Case 2 ...................................................... .5 A
Case-All Others ................................................ 1.5 A
Recommended Operatinq Conditions:
Output Voltage Range .................................... 1.2 to 37 VDC
Ambient Operating Temperature Range (TA) ................ - 55°C to + 125°C
Input Voltage Range ................................. 4.25 to 41.25 VDC
tli. (ii),]
OM1320NTM, OM1320STM, OM1320NKM, OM1320SMM, OM1320NMM, OM1320N2M
ELECTRICAL CHARACTERISTICS
-55°C s TA s 125°C, L = 8mA (unless otherwise speaTed)
OM1320NTM, OhM320STM, OM1320NKM, OM1320SMM, OM1320NMM
Parameter Symbol Test Conditions Min. Max. Unit
Reference Voltage VREF VDIFF = 3.0V, TA-- 25°C 1.20 1.30
Vom: = 3.3V 1.20 1.30 v
vDIFF = 40V 1.20 1.30
Line Regulation RLINE 3.0V s VDIFF S 40V, V001: Vref, TA = 25°C -9 9 mV
(Note 1) 3.3V s vaF s 40v, Vout = vref -23 23
Load Regulation RLOAD Vom: = 3.0V, 10mA s: Ls 1.5A, TA = 25''C -15 15
(Note 1) Vars = 3.3V, 10mA s: Ls 1.5A -15 15 mV
Vom: = 40V, 10mA s IL s 300mA, TA = 25°C -15 15
Voss: = MN, 10mA sILs195mA -15 15
Thermal Regulation VRTH Vin = 14.6V, L = 1.5A -16 16 mV
Pd = 20 Watts, t = 20 ms, TA =25°C
Ripple Rejection RN f= 120 Hz, Vout = ref 66 dB
(Note 2) CAdj = 10 pF
Adjustment Pin Current lpa VDIFF = 3.0V, TA = 25°C 100
Voss = 3.3V 100 pA
Vom: = 40V 100
Adjustment Pin Alpa Vom: = 3.0V, 10mA s ts 1.5A, TA = 25°C -5 5
Current Change VDIFF = 3.3V, 10mA s IL s 1.5A -5 5
Vom: = 40V, 10mA s IL s 300mA, TA = 25°C -5 5
vDIFF = 40V, 10mA s IL s 195mA -5 5 pA
3.0V S Var, s 40V, TA = 25°C -5 5
3.3V s Vom: s 40V -5 5
Miminum Load Current ILmin VDIFF = 3.0V, VOUT = 1.4V (forced) 5.0
vDIFF = 3.3V, I/our = 1.4V (forced) 5.0 mA
Vom: = 40V, kvr = 1.4V (forced) 5.0
Current Limit ICL VDIFF = 15V 1.5 3.5
(Note 2) Vars = 40V, TA = 25°C 0.18 1.5 A
Notes:
1. Load and Line Regulation are specified at a constantjunction temperature. Pulse testing with low duty cycle is used.
Changes in output voltage due to heating effects must be taken into account separately.
2. If not tested, shall be guaranteed to the specified limits.
3. The . denotes the specitications which apply over the full operating temperature range.
PART NUMBER DESIGNATOR
Standard Military Drawing Number
Omnirel Part Number
Omnirel Package Designation
7703401 M
7703401 U
7703401 T
7703401Y
7703401 N
0M1320$MM
OM1320$TM
OM1320NTM
OM1320 NKM
OM1320NMM
OM1320N2M
T0-257 (Isolated)
TO-257 (non-lsolated)
LCC-20
