Power Inductor # Technical Documentation: CDRH30D14RNP4R7MC Power Inductor
Manufacturer : SUMIDA
Component Type : Shielded Drum Core Inductor
Inductance Value : 4.7 µH
---
## 1. Application Scenarios
### Typical Use Cases
The CDRH30D14RNP4R7MC is specifically designed for power conversion applications requiring stable inductance under high current conditions. Typical implementations include:
- DC-DC Converters : Buck, boost, and buck-boost configurations in switching frequencies ranging from 500 kHz to 2 MHz
- Voltage Regulation Modules : Particularly in multi-phase VRM designs for processor power delivery
- Power Supply Filtering : Both input and output filtering in switched-mode power supplies
- Energy Storage : Temporary energy storage in power conversion circuits during switching cycles
### Industry Applications
- Consumer Electronics : Smartphones, tablets, laptops, and gaming consoles
- Automotive Systems : Infotainment systems, ADAS power supplies, and LED lighting drivers
- Industrial Equipment : PLCs, motor drives, and industrial automation power supplies
- Telecommunications : Base station power systems, network equipment, and RF power amplifiers
- Medical Devices : Portable medical equipment and diagnostic instrument power supplies
### Practical Advantages
- High Saturation Current : Maintains inductance stability up to 3.8A saturation current
- Low DC Resistance : 45mΩ typical DCR minimizes power losses
- Excellent Shielding : Reduced electromagnetic interference (EMI) to adjacent components
- Thermal Stability : Stable performance across -40°C to +125°C operating range
- Compact Size : 3.0mm height enables use in space-constrained designs
### Limitations
- Frequency Limitations : Performance degrades above 3MHz due to core material characteristics
- Current Handling : Not suitable for applications exceeding 4.0A continuous current
- Size Constraints : May not fit ultra-compact designs requiring components under 2mm height
- Cost Considerations : Higher cost compared to unshielded alternatives in high-volume applications
---
## 2. Design Considerations
### Common Design Pitfalls and Solutions
Pitfall 1: Inadequate Current Margin
- Issue : Operating near saturation current causes inductance drop and efficiency loss
- Solution : Design with 20-30% current margin above maximum operating current
Pitfall 2: Thermal Management
- Issue : Excessive temperature rise due to poor airflow or high RMS currents
- Solution : Implement thermal vias in PCB, ensure adequate spacing for airflow
Pitfall 3: Resonance Effects
- Issue : Self-resonant frequency limitations affecting high-frequency performance
- Solution : Characterize SRF (typically 25-35MHz) and design switching frequencies well below this limit
### Compatibility Issues
Capacitor Selection :
- Must pair with low-ESR ceramic capacitors for optimal filtering performance
- Avoid using with high-ESR aluminum electrolytic capacitors in critical filtering applications
Semiconductor Compatibility :
- Compatible with most modern switching ICs (TI, Analog Devices, Maxim)
- Ensure switching frequency compatibility with controller IC specifications
Magnetic Interference :
- Maintain minimum 2mm clearance from other magnetic components
- Avoid placement near sensitive analog circuits or RF components
### PCB Layout Recommendations
Placement Guidelines :
- Position close to switching ICs to minimize parasitic inductance in high-current paths
- Maintain minimum 1mm clearance from other components for manufacturability
Routing Considerations :
- Use wide, short traces for high-current paths (minimum 20 mil width for 3A current)
- Implement ground planes for improved EMI performance
- Route sensitive signal traces away from inductor magnetic field
Ther
