TSS1J48S ,SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSRTOSHIBA TSSIG48S,TSSL48STCC', GARQ TCC', MAC"m""'Iv,OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON, Unit ..
TSS2G45S ,SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSRTOSHIBA TSS2G45S,TSSL45S,TSS2G47S,TSSL47STSS2G45S, TSS2M5S, TSS2G47S, TSS2M7SOPTICALLY ISOLATED, ZE ..
TSS2G48S ,SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSRTOSHIBA TSS2G48S,TSS2J48ST§§7GAR§ TQQ? MACq0ti0ti.-NIIq IV”, I'u-‘ Iv,OPTICALLY ISOLATED, ZERO VOLT ..
TSS2J45S ,SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSRTOSHIBA TSS2G45S,TSSL45S,TSS2G47S,TSSL47STSS2G45S, TSS2M5S, TSS2G47S, TSS2M7SOPTICALLY ISOLATED, ZE ..
TSS2J45S. ,SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSRTOSHIBA TSS2G45S,TSSL45S,TSS2G47S,TSSL47STSS2G45S, TSS2M5S, TSS2G47S, TSS2M7SOPTICALLY ISOLATED, ZE ..
TSS2J47S ,SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSRTOSHIBA TSS2G45S,TSSL45S,TSS2G47S,TSSL47STSS2G45S, TSS2M5S, TSS2G47S, TSS2M7SOPTICALLY ISOLATED, ZE ..
UC285T-3 ,1 ..
UC285T-ADJ ,1maximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
UC285TD-ADJ ,1electrical characteristics unless otherwise stated, these parameters apply for T = −40°C to 100°CAf ..
UC285TDKTTT-1 ,1maximum ratings over operating free-air temperature (unless otherwise noted)VB . . . . . . . . . . ..
UC285TDKTTT-3 ,1electrical characteristics unless otherwise stated, these parameters apply for T = −40°C to 100°CAf ..
UC2860N , RESONANT MODE POWER SUPPLY CONTROLLER
TSS1J48S
SOLID STATE AC RELAY OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON ZERO CURRENT TURN-OFF, NORMALY OPEN SSR
TOSH I BA TSSIG48S,TSSL48S
TOSHIBA SOLID STATE AC RELAY
TSSI G48S, TSSI £485
OPTICALLY ISOLATED, ZERO VOLTAGE TURN-ON, Unit in mm
ZERO CURRENT TURN-OFF, NORMALLY OPEN SSR
COMPUTER PERIPHERALS
MACHINE TOOL CONTROLS
PROCESS CONTROL SYSTEMS
TRAFFIC CONTROL SYSTEMS
20.5 MAX.
R.M.S On-State Current .' IT(RMS)=1A
Non-Repetitive Peak Off-State Voltage : VDSM=400, 600V
TTL Compatible
Isolation Voltage : 2000V AC (t= 1min.)
2.5 MIN‘
0 Including Snubber Network
MAXIMUM RATINGS (Ta = 25°C) 1. OUTPUT (AC)
INPUT(CONTROL) 2. OUTPUT (AC)
3. INPUT(+)
CHARACTERISTIC SYMBOL RATING UNIT 4. INPUT(-)
Control Input Voltage (DC) V 5 5 V JEDEC -
(Note 1) FUN) . EIAJ -
Control Input Current(DC) IF (IN) 30 mA TOSHIBA 10-24C1A
OUTPUT (LOAD) Weight : 5g
Non-Repetitive Peak TSSlG48S V 400 V
Off-State Voltage TSSIJ48S DSM 600
Nominal AC Line TSSlG48S V 120 V
Voltage TSSIJ48S AC 240
R.M.S On-State Current IT (RMS) 1
Peak One Cycle Surge On-State I 20 (50Hz)
Current (Non-Repetitive) TSM 22 (60Hz)
Operating Frequency Range f 45~65 Hz
Isolation Voltage
(t=1min., Input to Output) BVS/AC 2000 V
Operating Temperature Range Topr -20-80 T
Storage Temperature Range Tstg -30--80 ''C
Note 1 .. Driving input rating : Insert an external resistance into SSR when the power supply
over 5.5V is used.
Note 2 : Mounting : Soldering of printed wiring board should be used under 260°C and 10
second.
1 2001-05-24
TOSH I BA TSSIG48S,TSSL48S
ELECTRICAL CHARACTERISTICS (Ta = 25°C)
INPUT (CONTROL)
CHARACTERISTIC SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT
Pick Up Voltage VFT - - 4.0 V
VAc=100V
Dro Out Volta rms - -
p . ge VFD Resistive Load 0.5 V
Input Resistance R (IN) - 160 - fl
OUTPUT (LOAD)
Off-State TSSIG4SS I VAc=100Vrms, f = 50Hz - - 1 mA
Leakage Current TSSIJ48S OL VAC=200Vrms, f-- 50Hz - -
Peak On-State Voltage VTM IT (RMS)=1A - - 1.5 V
dv/ dt(Off-State) dv/ dt VDSM=0.7XRated 50 - - V/ (rs
Minimum Load Current - 100 - - mA
Turn-On Time ton V AC=100Vrms - - 1/ 2 Cycle
Turn-Off Time toff Resistive Load(Fig.1) - - 1/ 2 Cycle
Isolation Resistance RS V=500V, R.H=40--60% 1010 - - Q
EQUIVALEN CIRCUIT
F ----ee--_--e------------H-ee----------H-ee---- ",
3 l, l o 1
+ o-i- - - l
l - R I
INPUT (D C) l LUMINOUS - DETECTIVE TRIGGER f: l OUTPUT ( A C)
l CIRCUIT - CIRCUIT CIRCUIT C l
- o l - - l
4 E -l''i,-, 2
AC LINE VOLTAGE fl
VAC l)
INPUT SIGNAL (DC)
VF (IN)
LOAD CURRENT 0
Fig.1 ZERO VOLTAGE SWITCHING WAVEFORM
2 2001-05-24
TOSHIBA
TSS1 G48S,TSSL48S
MAXIMUM ALLOWABLE AMBIENT
TEMPERATURE Ta MAX (°C)
PEAK SURGE ON~STATE CURRENT
ITSM (A)
Ta MAX - IT(RMS)
0.25 0.5 0.75 1.0 1.25
R.M.S ON-STATE CURRENT mms) (A)
SURGE ON-STATE CURRENT
RATED LOAD
3 5 10 30 50
NUMBER OF CYCLES AT 50Hz AND 60Hz
PT (AV) - IT (RMS)
PT (AV) (W)
AVERAGE ON-STATE POWER DISSIPATION
0 0.25 0.5 0.75 1.0 1.25 1.5
R.M.S ON-STATE CURRENT IT (RMS) (A)
TOSH I BA TSS1 G48S,TSSI J48S
RESTRICTIONS ON PRODUCT USE
000707EBA
OTOSHIBA is continually working to improve the quality and reliability of its products.
Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent
electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer,
when utilizing TOSHIBA products, to comply with the standards of safety in making a safe
design for the entire system, and to avoid situations in which a malfunction or failure of such
TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified
operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please
keep in mind the precautions and conditions set forth in the "Handling Guide for
Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc..
OThe TOSHIBA products listed in this document are intended for usage in general electronics
applications (computer, personal equipment, office equipment, measuring equipment, industrial
robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor
warranted for usage in equipment that requires extraordinarily high quality and/or reliability or
a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended
Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship
instruments, transportation instruments, traffic signal instruments, combustion control
instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA
products listed in this document shall be made at the customer's own risk.
0 The products described in this document are subject to the foreign exchange and foreign trade
OThe information contained herein is presented only as a guide for the applications of our
products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of
intellectual property or other rights of the third parties which may result from its use. No
license is granted by implication or otherwise under any intellectual property or other rights of
TOSHIBA CORPORATION or others.
0 The information contained herein is subject to change without notice.
4 2001-05-24
:
www.loq.com
.
