IC Phoenix
 
Home ›  TT38 > TL084A-TL084AIDT-TL084BIDT-TL084IYDT,JFET inputs, low input bias current
TL084A-TL084AIDT-TL084BIDT-TL084IYDT Fast Delivery,Good Price
Part Number:
If you need More Quantity or Better Price,Welcom Any inquiry.
We available via phone +865332716050 Email
Partno Mfg Dc Qty AvailableDescript
TL084ATEXASN/a595avaiGENERAL PURPOSEJ-FET QUAD OPERATIONAL AMPLIFIERS
TL084AIDTSTN/a2500avaiJFET inputs, low input bias current
TL084BIDTSTN/a2500avaiJFET inputs, low input bias current
TL084IYDTSTN/a2500avaiJFET inputs, low input bias current


TL084AIDT ,JFET inputs, low input bias currentFeaturesN+■ Wide common-mode (up to V ) and CCDIP14differential voltage range(Plastic package)■ Low ..
TL084BC , GENERAL PURPOSE J-FET QUAD OPERATIONAL AMPLIFIERS
TL084BCD ,GENERAL PURPOSE QUAD JFET OP-AMPS SLOS081I–FEBRUARY 1977–REVISED MAY 20155 Pin Configuration and FunctionsTL082 FK PackageTL081 and ..
TL084BCDR ,JFET-Input Operational AmplifierElectrical Characteristics for TL08xM and TL084x... 7 12.1 Documentation Support.... 206.7 Operatin ..
TL084BCDT ,GENERAL PURPOSE QUAD JFET OP-AMPSABSOLUTE MAXIMUM RATINGS Symbol Parameter TL084M, AM, BM TL084I, AI, BI TL084C, AC, BC Unit1 ..
TL084BCN ,GENERAL PURPOSE QUAD JFET OP-AMPSTL084TL084A - TL084BGENERAL PURPOSE J-FET QUAD OPERATIONAL AMPLIFIERS+ ■ WIDE COMMON-MODE (UP TO V ..
TLV2450CDBVR ,Single Micropower Rail-To-Rail Input/Output Op Amp w/ShutdownWWW.TI.COMPOST OFFICE BOX 1443 • HOUSTON, TEXAS 77251−1443      ..
TLV2450CDBVRG4 ,Single Micropower Rail-To-Rail Input/Output Op Amp w/Shutdownmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
TLV2450CDBVT ,Single Micropower Rail-To-Rail Input/Output Op Amp w/Shutdown          µ      ..
TLV2450IDBVR ,Single Micropower Rail-To-Rail Input/Output Op Amp w/Shutdownmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
TLV2450IDBVT ,Single Micropower Rail-To-Rail Input/Output Op Amp w/ShutdownWWW.TI.COMPOST OFFICE BOX 1443 • HOUSTON, TEXAS 77251−1443      ..
TLV2451AID ,Single Micropower Rail-To-Rail Input/Output Op Amp          µ      ..


TL084A-TL084AIDT-TL084BIDT-TL084IYDT
JFET inputs, low input bias current
January 2013 Doc ID 2301 Rev 5 1/19
TL084, TL084A, TL084B

General purpose JFET quad operational amplifiers
Datasheet — production data
Features
Wide common-mode (up to VCC+ ) and
differential voltage range Low input bias and offset current Output short-circuit protection High input impedance JFET input stage Internal frequency compensation Latch up free operation High slew rate: 16 V/µs (typical)
Description

The TL084, TL084A, and TL084B are high-speed,
JFET input, quad operational amplifiers
incorporating well matched, high voltage JFET
and bipolar transistors in a monolithic integrated
circuit.
The devices feature high slew rates, low input
bias and offset currents, and low offset voltage
temperature coefficient.
Contents TL084, TL084A, TL084B
2/19 Doc ID 2301 Rev 5
Contents Schematic diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Absolute maximum ratings and operating conditions . . . . . . . . . . . . . 4 Electrical characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Parameter measurement information . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Typical applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

6.1 DIP14 package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
6.2 TSSOP14 package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
6.3 SO-14 package information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Ordering information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Revision history . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
TL084, TL084A, TL084B Schematic diagram 3/19
1 Schematic diagram
Figure 1. Circuit schematics (for each amplifier)
Absolute maximum ratings and operating conditions TL084, TL084A, TL084B
4/19 Doc ID 2301 Rev 5 Absolute maximum ratings and operating conditions
Table 1. Absolute maximum ratings All voltage values, except differential voltage, are with respect to the zero reference level (ground) of the supply voltages where the zero reference level is the midpoint between VCC+ and VCC-. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 volts, whichever is less. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. Short-circuits can cause excessive heating and destructive dissipation. Rth are typical values. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be limited to ensure that the dissipation rating is not exceeded. Human body model: 100 pF discharged through a 1.5 kΩ resistor between two pins of the device, done for all couples of pin combinations with other pins floating. Machine model: a 200 pF cap is charged to the specified voltage, then discharged directly between two pins of the device with no external series resistor (internal resistor < 5 Ω), done for all couples of pin combinations with other pins floating. Charged device model: all pins plus package are charged together to the specified voltage and then discharged directly to the ground.
TL084, TL084A, TL084B Absolute maximum ratings and operating conditions
Doc ID 2301 Rev 5 5/19
Table 2. Operating conditions
Electrical characteristics TL084, TL084A, TL084B
6/19 Doc ID 2301 Rev 5
3 Electrical characteristics

Table 3. VCC = ±15 V, Tamb = +25 °C (unless otherwise specified)
TL084, TL084A, TL084B Electrical characteristics
Doc ID 2301 Rev 5 7/19 The input bias currents are junction leakage currents which approximately double for every 10°C increase in the junction temperature.
Table 3. VCC = ±15 V, Tamb = +25 °C (unless otherwise specified) (continued)
Electrical characteristics TL084, TL084A, TL084B Doc ID 2301 Rev 5



Figure 2. Maximum peak-to-peak output
voltage vs. frequency (RL = 2 kΩ)
Figure 3. Maximum peak-to-peak output
voltage vs. frequency (RL = 10 kΩ)
Figure 4. Maximum peak-to-peak output
voltage vs. frequency and temp.
Figure 5. Maximum peak-to-peak output
voltage vs. free air temp.
Figure 6. Maximum peak-to-peak output
voltage vs. load resistance
Figure 7. Maximum peak-to-peak output
voltage vs. supply voltage
TL084, TL084A, TL084B Electrical characteristics
Doc ID 2301 Rev 5 9/19



Figure 8. Input bias current vs. free air
temp.
Figure 9. Large signal differential voltage
amplification vs. free air temp.
Figure 10. Large signal differential voltage
amplification and phase shift vs.
frequency
Figure 11. Total power dissipation vs. free air
temp.
Figure 12. Supply current per amplifier vs.
free air temp.
Figure 13. Supply current per amplifier vs.
supply voltage
Electrical characteristics TL084, TL084A, TL084B Doc ID 2301 Rev 5



Figure 14. Common mode rejection ratio vs.
free air temp.
Figure 15. Voltage follower large signal pulse
response
Figure 16. Output voltage vs. elapsed time Figure 17. Equivalent input noise voltage vs.
frequency
Figure 18. Total harmonic distortion vs.
frequency
ic,good price


TEL:86-533-2716050      FAX:86-533-2716790
   

©2020 IC PHOENIX CO.,LIMITED