RC6704M ,Triple Fixed Gain Video Amp with Enable Amplifiers number of 3Features Description• Triple video amplifier with internal resistors to set gains to The RC6704 cons ..
RCA ,Automotive Grade, Thick Film, Rectangular Chip Resistors in Europe contact : ff1aresistors Document Number 2003438 in Americas/Asia contact : ff2aresisto ..
RCD16-47B ,RCD NETWORK FOR BUS TERMINATIONAPPLICATIONSIn any electronic equipment where a suitable busterminationis requiredto avoidsignalref ..
RCD1647B6 ,RCD NETWORK FOR BUS TERMINATIONFEATURESFUNCTIONAL DIAGRAMNETWORK OF16R-C-D LINETERMINATIONSRESISTANCE : R = 47 Ω, TOLERANCE +/- 10 ..
RCJ450N20 , 10V Drive Nch MOSFET
RCLAMP0504F.TCT , RailClamp® Low Capacitance TVS Array
RJK0602DPN-E0 , N-Channel MOS FET 60 V, 100 A, 3.9 m.
RJK0603DPN-E0 , N-Channel MOS FET 60 V, 80 A, 5.2 m
RJK0628JPE , Silicon N Channel MOS FET High Speed Power Switching
RJK0629DPE , 60V, 85A, 4.5m max. N Channel Power MOS FET High-Speed Switching Use
RJK0629DPN , 60V, 85A, 4.5m max. N Channel Power MOS FET High-Speed Switching Use
RJK0629JPE , 60 V - 85 A - Silicon N Channel MOS FET High Speed Power Switching
RC6704M
Triple Fixed Gain Video Amp with Enable Amplifiers number of 3
Features Triple video amplifier with internal resistors to set gains to
+2, +1, and -1 Independently enabled amplifiers 60 MHz -3 dB Bandwidth (A
= 2) 20 MHz
0.1 dB gain flatness 0.06% differential gain (A
= 2, R
= 150 0.06
differential phase (A
= 2, R
= 150 High CMRR (75 dB), High PSRR (70 dB) Dual
5V power supply Low offset 2.0 mV 16-pin narrow SOIC package 300 V/
s slew rate Fast settling time: 0.1% in 35 ns Voltage gain accuracy better than 0.5% TTL or CMOS compatible enable inputs
Applications RGB amplifier 3:1 crosspoint switch RGB switch Video instrumentation amplifier Selectable gain amplifier Programmable filter Active filter
DescriptionThe RC6704 consists of three low power, wide band voltage
feedback operational amplifiers. Internal thin-film gain set-
ting resistors provide gains of +2, +1 and -1. Each channel is
capable of delivering a load current of at least 35mA.
Each amplifier can be independently enabled or disabled
with a TTL or CMOS signal. When disabled, the amplifier is
in a high impedance output state, presenting a very high
input to output isolation. The layout is optimized for low
channel to channel crosstalk.
The amplifiers are optimized for video applications where
low differential gain and low phase distortion are significant
requirements.
