MC14504BDR2G , Hex Level Shifter for TTL to CMOS or CMOS to CMOS
MC14504BFEL ,Hex Level ShifterMaximum ratings applied to the device are individual stress limit values (notnormal operating condi ..
MC14504BFEL ,Hex Level ShifterMaximum ratings are those values beyond which device damage can occur.dimensions section on page 2 ..
MC145050DW ,10-Bit A/D Converter with Serial InterfaceMaximum Ratings are those values beyond which damage to the device may occur. Func-tional operation ..
MC145050P ,10-Bit A/D Converter with Serial InterfaceELECTRICAL CHARACTERISTICS(Voltages Referenced to V , Full Temperature and Voltage Ranges per Opera ..
MC145051DW ,10-Bit A/D Converter with Serial InterfaceMAXIMUM RATINGSSymbol Parameter Value UnitThis device contains protection circuitry toguard against ..
MC68HC705P9MDW ,Microcontroller, 2104 bytes, 48 bytes EPROM, 128 bytes RAM
MC68HC711D3CFN2 ,Microcontrollers
MC68HC711D3CFN2 ,Microcontrollers
MC68HC711D3CFN3 ,Microcontrollers
MC68HC711D3CFN3 ,Microcontrollers
MC68HC711D3CFNE2 , Power Saving STOP and WAIT Modes
MC14504B-MC14504BDR2-MC14504BFEL
Hex Level Shifter
MC14504B
Hex Level Shifter for TTL to
CMOS or CMOS to CMOS
The MC14504B is a hex non−inverting level shifter using CMOS
technology. The level shifter will shift a TTL signal to CMOS logic
levels for any CMOS supply voltage between 5 and 15 volts. A control
input also allows interface from CMOS to CMOS at one logic level to
another logic level: Either up or down level translating is
accomplished by selection of power supply levels VDD and VCC. The
VCC level sets the input signal levels while VDD selects the output
voltage levels.
Features UP Translates from a Low to a High V oltage or DOWN Translates
from a High to a Low Voltage Input Threshold Can Be Shifted for TTL Compatibility No Sequencing Required on Power Supplies or Inputs for Power Up
or Power Down 3 to 18 Vdc Operation for VDD and VCC Diode Protected Inputs to VSS Capable of Driving Two Low−Power TTL Loads or One Low−Power
Schottky TTL Load Over the Rated Temperature Range Pb−Free Packages are Available*
MAXIMUM RATINGS (Voltages Referenced to VSS)Maximum ratings are those values beyond which device damage can occur.
Maximum ratings applied to the device are individual stress limit values (not
normal operating conditions) and are not valid simultaneously. If these limits are
exceeded, device functional operation is not implied, damage may occur and
reliability may be affected. Temperature Derating:
Plastic “P and D/DW” Packages: – 7.0 mW/�C From 65�C To 125�C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high−impedance circuit. For proper operation, Vin and Vout should be constrained
to the range VSS � (Vin or Vout) � VDD.
