MC14175BFR2 ,Quad Type D Flip-FlopELECTRICAL CHARACTERISTICS (Voltages Referenced to V )SSÎÎÎÎÎÎ – 55* CÎÎ 25* CÎÎÎÎÎ 125* CÎÎÎV VDD ..
MC14194B , 4-Bit Bidirectional Universal Shift Register
MC14194BCP ,4-Bit Bidirectional Universal Shift RegisterMAXIMUM RATINGS* (Voltages Referenced to V ) MC14XXXBD SOICSSÎÎÎÎÎÎT = – 55° to 125°C for all packa ..
MC142100 ,4 X 4 CROSSPOINT SWITCH WITH CONTROL MEMORYMCI42100MOTOROLA MC1451004 X 4 CROSSPOINT SWITCH WITH CONTROL MEMORYThe MC142100 and MC145100consis ..
MC142100CP ,4 X 4 CROSSPOINT SWITCH WITH CONTROL MEMORYMCI42100MOTOROLA MC1451004 X 4 CROSSPOINT SWITCH WITH CONTROL MEMORYThe MC142100 and MC145100consis ..
MC143150B1FU1 ,V(cc): -0.3 to +7.0V; V(in): -0.3 to +0.3V; 200mA; 800mW; bus interrupter moduleSECTION 6Neuron CHIP ELECTRICAL AND MECHANICAL SPECIFICATIONS6.1 INTRODUCTIONThe Neuron Chip proces ..
MC68HC11E1CFU3 , 8-channel, 8-bit analog-to-digital (A/D) converter
MC68HC11E1CFU3 , 8-channel, 8-bit analog-to-digital (A/D) converter
MC68HC11E1CFU3 , 8-channel, 8-bit analog-to-digital (A/D) converter
MC68HC11E9 , 8-channel, 8-bit analog-to-digital (A/D) converter
MC68HC11E9 , 8-channel, 8-bit analog-to-digital (A/D) converter
MC68HC11E9 , 8-channel, 8-bit analog-to-digital (A/D) converter
MC14175BFR2
Quad Type D Flip-Flop
---The MC14175B quad type D flip–flop is constructed with MOS
P–channel and N–channel enhancement mode devices in a single
monolithic structure. Each of the four flip–flops is positive–edge
triggered by a common clock input (C). An active–low reset input (R)
asynchronously resets all flip–flops. Each flip–flop has independent
Data (D) inputs and complementary outputs (Q and Q). These devices
may be used as shift register elements or as type T flip–flops for
counter and toggle applications. Complementary Outputs Static Operation All Inputs and Outputs Buffered Diode Protection on All Inputs Supply Voltage Range = 3.0 Vdc to 18 Vdc Output Compatible with Two Low–Power TTL Loads or One
Low–Power Schottky TTL Load Functional Equivalent to TTL 74175
MAXIMUM RATINGS (Voltages Referenced to VSS) (Note 2.) Maximum Ratings are those values beyond which damage to the device
may occur. Temperature Derating:
Plastic “P and D/DW” Packages: – 7.0 mW/ C From 65 C To 125C
This device contains protection circuitry to guard against damage due to high
static voltages or electric fields. However, precautions must be taken to avoid
applications of any voltage higher than maximum rated voltages to this
high–impedance circuit. For proper operation, Vin and Vout should be constrained
to the range VSS (Vin or Vout) VDD.
Unused inputs must always be tied to an appropriate logic voltage level (e.g.,
either VSS or VDD). Unused outputs must be left open.
