MAX6964ATG Fast Delivery |IC PHOENIX CO.,LIMITED

MAX6964ATG ,17- OUTPUT LED DRIVER/GPOMAX696419-3179; Rev 0; 1/0417- LED/GPO____________ ____________TM2MAX6964 I C♦ 400kbps, 2- , 5.5V 1 ..
MAX6964ATG+ ,17-Output LED Driver/GPO with Intensity Control and Hot-Insertion ProtectionMAX696419-3179; Rev 3; 3/0517-Output LED Driver/GPO with Intensity Control and Hot-Insertion Protec ..
MAX6965AEE+ ,9-Output LED Driver with Intensity Control and Hot-Insertion ProtectionApplications0.047µFLCD BacklightsLED Status Indication V+Keypad BacklightsµCMAX6965RGB LED Drivers ..
MAX6965AEE+ ,9-Output LED Driver with Intensity Control and Hot-Insertion ProtectionMAX696519-3058; Rev 3; 3/059-Output LED Driver with Intensity Control and Hot-Insertion Protection
MAX6965ATE+ ,9-Output LED Driver with Intensity Control and Hot-Insertion ProtectionFeatures2♦ 400kbps, 2-Wire Serial Interface, 5.5V TolerantThe MAX6965 I C-compatible serial inter ..
MAX6965ATE+T ,9-Output LED Driver with Intensity Control and Hot-Insertion ProtectionELECTRICAL CHARACTERISTICS(Typical Operating Circuit, V+ = 2V to 3.6V, T = T to T , unless otherwis ..
MB401 , 40 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
MB401 , 40 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
MB401 , 40 Amp Single Phase Bridge Rectifier 50 to 1000 Volts
MB40166 ,AD/DA CONVERTERFUJITSU SEMICONDUCTORDS04-28500-5EDATA SHEETASSPAD/DA CONVERTERMB40166/MB401761-CHANNEL 6-BIT AD/DA ..
MB40176 ,AD/DA CONVERTERFUJITSU SEMICONDUCTORDS04-28500-5EDATA SHEETASSPAD/DA CONVERTERMB40166/MB401761-CHANNEL 6-BIT AD/DA ..
MB40176 ,AD/DA CONVERTERFUJITSU SEMICONDUCTORDS04-28500-5EDATA SHEETASSPAD/DA CONVERTERMB40166/MB401761-CHANNEL 6-BIT AD/DA ..

MAX6964ATG
17- OUTPUT LED DRIVER/GPO
________________________________
MAX6964I2CTM
50mA 7V LED7V PWM . 4-
LED . .
. LEDBLINK(1kHz)
. BLINK
LED
(GPI).
MAX69642-I2C , 42C .
________________________________
________________________________400kbps, 2-, 5.5V 2V~3.6V 8-PWM LED 2-LED —50mA () RST 7V (1.2µA () 3.3µA ())4mm x 4mm, 0.8mm QFN -40°C~+125°C
MAX6964
17-LED
/GPO
_________________________________
________________________
19-3179; Rev 0; 1/04
________________________________
LCD
LED RGB LED
Maxim Integrated Products I2C
I2C I2C
MAX6964
17-LED
/GPO
ABSOLUTE MAXIMUM RATINGS
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Voltage (with respect to GND).............................................................................-0.3V to +4V
SCL, SDA, AD0, BLINK, RST...................................-0.3V to +6V
O0–O16....................................................................-0.3V to +8V
DC Current on O0 to O16...................................................55mA
DC Current on SDA.............................................................10mA
Maximum GND Current....................................................350mA
Continuous Power Dissipation (TA= +70°C)
24-Pin QSOP (derate 9.5mW/°C over +70°C)..............761mW
24-Pin QFN (derate 20.8mW/°C over +70°C)............1666mW
Operating Temperature Range.........................-40°C to +125°C
Junction Temperature......................................................+150°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10s).................................+300°C
ELECTRICAL CHARACTERISTICS
(Typical Operating Circuit, V+ = 2V to 3.6V, TA= TMINto TMAX, unless otherwise noted. Typical values are at V+ = 3.3V, TA = +25°C.)
MAX6964
17-LED
/GPO
ELECTRICAL CHARACTERISTICS (continued)
(Typical Operating Circuit, V+ = 2V to 3.6V, TA= TMINto TMAX, unless otherwise noted. Typical values are at V+ = 3.3V, TA= + 25°C.)
(Note 1)
TIMING CHARACTERISTICS
(Typical Operating Circuit, V+ = 2V to 3.6V, TA= TMINto TMAX, unless otherwise noted. Typical values are at V+ = 3.3V, TA = +25°C.)
MAX6964
17-LED
/GPO
PORT OUTPUT LOW VOLTAGE WITH 50mA
LOAD CURRENT vs. TEMPERATURE
PORT OUTPUT LOW VOLTAGE V
(V)
MAX6964 toc04
PORT OUTPUT LOW VOLTAGE WITH 20mA
LOAD CURRENT vs. TEMPERATURE
MAX6964 toc05
PORT OUTPUT LOW VOLTAGE V
(V)
PWM CLOCK FREQUENCY
vs. TEMPERATURE
MAX6964 toc06
PWM CLOCK FREQUENCY (kHz)
STANDBY CURRENT vs. TEMPERATURE
MAX6964 toc01
TEMPERATURE (°C)
STANDBY CURRENT (
SUPPLY CURRENT vs. TEMPERATURE
(PWM DISABLED; fSCL = 400kHz)
MAX6964 toc02
TEMPERATURE (°C)
SUPPLY CURRENT (
SUPPLY CURRENT vs. TEMPERATURE
(PWM ENABLED; fSCL = 400kHz)
MAX6964 toc03
TEMPERATURE (°C)
SUPPLY CURRENT (
___________________________________________________________________
(TA = +25°C, unless otherwise noted.)
TIMING CHARACTERISTICS (continued)
(Typical Operating Circuit, V+ = 2V to 3.6V, TA= TMINto TMAX, unless otherwise noted. Typical values are at V+ = 3.3V, TA = +25°C.)
(Note 1)
Note 1:All parameters tested at TA= +25°C. Specifications over temperature are guaranteed by design.
Note 2:A master device must provide a hold time of at least 300ns for the SDA signal (referred to VILof the SCL signal) to bridge
the undefined region of SCL’s falling edge.
Note 3:Guaranteed by design.
Note 4:Cb= total capacitance of one bus line in pF. tRand tFmeasured between 0.3 x VDDand 0.7 x VDD.
Note 5:ISINK≤6mA. Cb= total capacitance of one bus line in pF. tRand tFmeasured between 0.3 x VDDand 0.7 x VDD.
Note 6:Input filters on the SDA and SCL inputs suppress noise spikes less than 50ns.
MAX6964
17-LED
/GPO
SCOPE SHOT OF OUTPUT PORTS
MAX6964 toc07
2ms/div
OUTPUT 1,
2V/div
OUTPUT 2,
2V/div
SCOPE SHOT OF OUTPUT PORTS
MAX6964 toc08
2ms/div
OUTPUT 1
2V/div
OUTPUT 2
2V/div
SINK CURRENT vs. VOL
MAX6964 toc09
SINK CURRENT (mA)
(V)302010
______________________________________________________________()
(TA = +25°C, unless otherwise noted.)
MAX6964
________________________________
MAX6964(GPO) , I2C-
O0-O1617MAX6964
50mA .
MAX6964350mA17
20mA. 1
MAX6964. .
LED O0-O15166). 7). (BLINK (0 (4).O162164).
BLINK 4).
BLINK (GPI .
PWM
MAX696432kHz
LED PWM . PWM
MAX6964
PWM LED 8). PWM
MAX6964 .
PWM 4-4-1112). 4-
PWM 16.
PWM 1/1515/154-,
1/16
15/16.
PWM
PWM 240811).
17-LED
/GPO
RAM
MAX69642 ,
RAM(2).
RST0xFF 3).
(idle) PWM
MAX6964.
PWM PWM
(active)I2C MAX6964
__________________________
MAX6964I2C 2-
(SDA)(SCL)(MAX6964
SCL 2).
MAX6964 SDA
. SDA4.7kΩ
. 2-
SCL
SCL4.7kΩ.3),
MAX69647R/W,
, 1, 3).
SCLSDA .
SCLSDA
START(S) .
SCL
SDASTOP(P) 3).
. SDA
SDL(4).5). 9
SDA
SDA .
MAX6964
MAX6964
17-LED
/GPO
MAX6964
. MAX6964
MAX69647-(
6). 7-8R/W.
R/W,
MAX6964 2(A5), 3(A4), 4(A3), (A1), (A0) 1, 0, 0, 0, 0. A2AD0.
AD0GND, V+, SDA, SCL.
MAX69644(1). MAX6964
MAX6964
MAX6964MAX6964R/W, 1.
MAX69642).
MAX6964
17-LED
/GPO
MAX6964(8).
MAX6964(2).0
MAX6964
MAX6964.
MAX6964
17-LED
/GPO
MAX6964
17-LED
/GPO
MAX6964(7).
MAX6964n
read-after-writer 2).
MAX69642-
MAX6964MAX69642).MAX69642MAX6964
MAX69642).
RST.
RSTMAX69643). MAX6964
START .
________________________________
RST
MAX6964(3).PWM
. RST
LED ()
PWM
, O16 , BLINK 4).1(BLINK((4).
LED .0xFFBLINK LED BLINK PWM
LED 4).
BLINK EXOR,1 115).4).
BLINK4).
BLINK
(GPI). BLINKGPI4).16
(O0-O15)(6). 7). .O162,
MAX6964
17-LED
/GPO
MAX6964
17-LED
/GPO

Partno	Mfg	Dc	Qty	Available	Descript
MAX6964ATG	MAXIM	N/a	142	avai	17- OUTPUT LED DRIVER/GPO