LMH6639MA/NOPB ,190MHz Rail-to-Rail Output Amplifier with Disable 8-SOIC -40 to 85FEATURES DESCRIPTIONThe LMH6639 is a voltage feedback operational2• (V = 5V, Typical Values Unless ..
LMH6639MFX ,190MHz Rail-to-Rail Output Amplifier with Disable
LMH6640MF ,TFT-LCD Single, 16V, Rail-to-Rail High Output Operational Amplifier
LMH6640MFX ,TFT-LCD Single, 16V, Rail-to-Rail High Output Operational Amplifier
LMH6640MFX ,TFT-LCD Single, 16V, Rail-to-Rail High Output Operational Amplifier
LMH6640MFX ,TFT-LCD Single, 16V, Rail-to-Rail High Output Operational Amplifier
LQH32MN680J23L , Chip Inductor (Chip Coil) for General Use Wire Wound Type
LQH3N151K34 , CHIP COIL
LQH3N180K34 , CHIP COIL
LQH3N271K34 , CHIP COIL
LQH3N2R7K34 , CHIP COIL
LQH3NPN100MM0L , Chip Inductor (Chip Coil) Power Inductor (Wire Wound Type) LQH3NP_M0 Series (1212 Size)
LMH6639MA/NOPB
190MHz Rail-to-Rail Output Amplifier with Disable 0-DIESALE
75:
SHUTDOWN INPUT
10n
100n
LMH6639
1FEATURES isa voltage feedback operational
(VS= 5V, Typical Values Unless Specified) witha rail-to-rail output drive capabilityof
• Supply Current (No Load) 3.6mA Employing TI’s patented VIP10 process, the
Supply Current (Off Mode) 400μA deliversa bandwidth of 190MHz ata consumptionof only 3.6mA. An input common
• Output Resistance (Closed Loop 1MHz) 0.186Ω voltage range extendingto 0.2V below theV−
−3dB BW (AV=1) 190MHz within 1VofV+, makes the LMH6639a true
• Settling Time 33nsec supply op-amp. The output voltage range within 30mVof either supply rail providing
• Input Common Mode Voltage −0.2Vto 4Va dynamic range thatis especially
• Output Voltage Swing 40mV from Rails low voltage applications.
• Linear Output Current 110mA offersa slew rateof 172V/μs resulting
• Total Harmonic Distortion −60dBc bandwidthof approximately 28MHz.
• Fully Characterized for 3V, 5V and ±5V also offers protection for the input by using two anti-parallel diodes anda
• No Output Phase Reversal with CMVR connected across the inputs. The TON
Exceeded combined witha settling timeof
• Excellent Overdrive Recovery this device ideally suited for
• Off Isolation 1MHz −70dB applications (see application note for attention has been paidto ensure
• Differential Gain 0.12% under all operating voltages and
• Differential Phase 0.045° resultisa very well behaved frequency for any gain setting including
APPLICATIONS specifications for driving video harmonic distortion of −60dBc,
• Active Filters gainof 0.12% and differential phaseof
• CD/DVD ROM• ADC Buffer Amplifier Portable Video Current Sense Buffer1. Typical
