KA3511DS ,Intelligent Voltage Mode PWM ICKA3511DSIntelligent Voltage Mode PWM IC
KA3524 ,SMPS ControllerFeatures Description• Complete PWM power control circuit The KA3524 regulating pulse width modu ..
KA3525A ,SMPS ControllerKA3525ASMPS Controller
KA3525AD ,SMPS CONTROLLERELECTRICAL CHARACTERISTICS(V = 20V, T = -35˛ to + 85˛, unless otherwise specified)CC ACharacteristi ..
KA-3528EC , 3.5 x 2.8mm SURFACE MOUNT LED LAMPS
KA-3528SGC , 3.5 x 2.8mm SURFACE MOUNT LED LAMPS
KRA302V , EPITAXIAL PLANAR PNP TRANSISTOR
KRA303 , EPITAXIAL PLANAR PNP TRANSISTOR (SWITCHING, INTERFACE CIRCUIT AND DRIVER CIRCUIT)
KRA303 , EPITAXIAL PLANAR PNP TRANSISTOR (SWITCHING, INTERFACE CIRCUIT AND DRIVER CIRCUIT)
KRA303E , EPITAXIAL PLANAR PNP TRANSISTOR
KRA304E , EPITAXIAL PLANAR PNP TRANSISTOR
KRA304V , EPITAXIAL PLANAR PNP TRANSISTOR
KA3511
Intelligent Voltage Mode PWM IC
Features Complete PWM control and house keeping circuitry Few external components Precision voltage reference trimmed to 2% Dual output for push-pull operation Each output TR for 200mA sink current Variable duty cycle by dead time control Soft start capability by using dead time control Double pulse suppression logic Over voltage protection for 3.3V / 5V / 12V Under voltage protection for 3.3V / 5V / 12V One more external input for various protection (PT) Remote on/off control function (PS-ON) Latch function controlled by remote and protection input Power good signal generator with hysteresis
Precision reference sectionThe reference voltage trimmed to ± 2%
(4.9V ≤ Vref ≤ 5.1V)
PG (Power good signal generator) sectionPower good signal generator is to monitor the voltage level
of power supply for safe operation of a microprocessor.
KA3511BS requires few external components to accomplish
a complete housekeeping circuits for SMPS.
DescriptionThe KA3511BS is a fixed frequency improved performance
pulse width modulation control circuit with complete
housekeeping circuitry for use in the secondary side of
SMPS (Switched mode power supply). It contains various
functions, which are precision voltage reference, over
voltage protection, under voltage protection, remote on/off
control, power good signal generator and etc.
OVP (Over voltage protection) sectionIt has OVP functions for +3.3V,+5V,+12V and PT outputs.
The circuit is made up of a comparator with four detecting
inputs and without hysteresis voltage. Especially, PT (Pin18)
is prepared for an extra OVP input or another protection
signal.
UVP (Under voltage protection) sectionIt also has UVP functions for +3.3V, +5V , +12V outputs. The
block is made up of a comparator with three detecting inputs
and without hysteresis voltage.
Remote on/off sectionRemote on/off section is used to control SMPS externally. If
a high signal is supplied to the remote on/off input, PWM
signal becomes a high state and all secondary outputs are
grounded. The remote on/off signal is transferred with some
on-delay and off-delay time of 8ms, 24ms respectively.
