74LVC1G07GW ,Buffer with open-drain outputPin configuration. Fig.2 Logic symbol.Yhandbook, halfpagehandbook, halfpage2 4A YAMNA624GND MNA625 ..
74LVC1G07SE-7 , SINGLE BUFFER/DRIVER WITH OPEN DRAIN OUTPUT
74LVC1G08GF ,Single 2-input AND gateFeatures and benefits Wide supply voltage range from 1.65 V to 5.5 V High noise immunity Complie ..
74LVC1G08GM ,Single 2-input AND gatePin configuration SOT353-1 and SOT753 Fig 5.
74LVC1G08GV ,Single 2-input AND gatePin configuration SOT886 74LVC1G0874LVC1G08B 1 5 VCCB 1 6 VCC3GNDA 2 5 n.c.A 2 4 YGND 3 4 Y001aae97 ..
74LVC1G08GW ,Single 2-input AND gatePin configuration SOT891, SOT1115 and Fig 7.
80SQ035 ,35V 8A Schottky Discrete Diode in a DO-204AR packageapplications are inI Rectangular 8 AF(AV)switching power supplies, converters, free-wheeling diodes ..
80SQ035TR ,35V 8A Schottky Discrete Diode in a DO-204AR packageFeaturesThe 80SQ axial leaded Schottky rectifier series has beenoptimized for low reverse leakage a ..
80SQ040 ,40V 8A Schottky Discrete Diode in a DO-204AR packageBulletin PD-2.047 rev. E 12/0180SQ... SERIESSCHOTTKY RECTIFIER8 AmpMajor Ratings and Characte ..
80SQ045 ,45V 8A Schottky Discrete Diode in a DO-204AR packageapplications are inI Rectangular 8 AF(AV)switching power supplies, converters, free-wheeling diodes ..
8102302PA ,Dual Low-Power JFET-Input General-Purpose Operational AmplifierElectrical Characteristics for TL06xM and TL064M.. 712.4 Trademarks..... 216.10 Operating Character ..
81487EIB ,【15kV ESD Protected, 1/8 Unit Load, 5V, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers
74LVC1G07GW
Buffer with open-drain output
Philips Semiconductors Product specification
Buffer with open-drain output 74L VC1G07
FEATURES Wide supply voltage range from 1.65to 5.5V High noise immunity Complies with JEDEC standard: JESD8-7 (1.65to 1.95V) JESD8-5 (2.3to 2.7V) JESD8B/JESD36 (2.7to 3.6V). 24 mA output drive (VCC= 3.0V) CMOS low power consumption Latch-up performance ≤250 mA Direct interface with TTL levels Inputs accept voltages up to 5V SOT353 package.
DESCRIPTIONThe 74LVC1G07 is a high-performance, low-power,
low-voltage, Si-gate CMOS device, superior to most
advanced CMOS compatible TTL families.
The input can be driven from either 3.3or5 V devices.
This feature allows the useof this deviceas translatorina
mixed 3.3 and5 V environment.
Schmitt trigger actionat the input makes the circuit tolerant
for slower input rise and fall time.
The 74LVC1G07 provides the non-inverting buffer.
The output of the device is an open drain and can be
connected to other open-drain outputs to implement
active-LOW wired-OR or active-HIGH wired-AND
functions.
QUICK REFERENCE DATAGND=0 V; Tamb =25 °C; tr =tf≤ 2.5 ns.
Notes CPD is used to determine the dynamic power dissipation (PDin μW). =CPD× VCC2×fi +(CL× VCC2×fo) where: = input frequency in MHz;= output frequency in MHz;= output load capacitance in pF;
VCC= supply voltage in Volts. The condition is VI= GND to VCC.
FUNCTION TABLESee note1.
Note H= HIGH voltage level;= LOW voltage level;= high-impedance OFF-state.
Philips Semiconductors Product specification
Buffer with open-drain output 74L VC1G07
ORDERING INFORMATION
PINNING
Philips Semiconductors Product specification
Buffer with open-drain output 74L VC1G07
RECOMMENDED OPERATING CONDITIONS
LIMITING VALUES accordance with the Absolute Maximum Rating System (IEC 60134); voltages are referencedto GND (ground=0 V).
Notes The input and output voltage ratings may be exceeded if the input and output current ratings are observed. When VCC=0 V (Power-down mode), the output voltage can be 5.5 V in normal operation. Above 55 °C the value of PD derates linearly with 2.5 mW/K.
Philips Semiconductors Product specification
Buffer with open-drain output 74L VC1G07
DC CHARACTERISTICSAt recommended operating conditions; voltages are referenced to GND (ground=0V).
Note All typical values are measured at VCC= 3.3 V and Tamb =25 °C.
Philips Semiconductors Product specification
Buffer with open-drain output 74L VC1G07
CHARACTERISTICSGND=0 V; tr =tf≤ 2.0 ns.
WAVEFORMS
