74LS48 ,BCD-to-Seven-Segment Decoder Driver(Internal Pull-up outputs)
74LS51 ,Dual 2-Wide 2-Input/ 2-Wide 3-Input AND-OR-INVERT GateGeneral DescriptionThis device contains two independent combinations ofgates each of which performs ..
74LS541 ,OCTAL BUFFER/LINE DRIVER WITH 3-STATE OUTPUTS
74LS541 ,OCTAL BUFFER/LINE DRIVER WITH 3-STATE OUTPUTS
74LS541 ,OCTAL BUFFER/LINE DRIVER WITH 3-STATE OUTPUTS
74LS624 , VOLTAGE-CONTROLLED OSCILLATORS
7B33-01-2 ,Isolated Voltage Input Signal Conditioning Module -100 Hz Bandwidthapplications protection. The power supplies necessary to drive each of the including process contro ..
7B34-01-2 ,Isolated 2 or 3-Wire RTD Input Signal Conditioning Moduleapplications protection. The power supplies necessary to drive each of the including process contro ..
7B34-02-2 ,Isolated 2 or 3-Wire RTD Input Signal Conditioning Modulefeatures a nonlinearity of +0.05% maximum (Pt RTDs). To accurately measure low level signals in el ..
7B35-01-2 ,Isolated Process Current Input Signal Conditioning Module with Isolated 24 V Loop Powerapplications protection. The power supplies necessary to drive each of the including process contro ..
7B37-J-01-2 ,Isolated Thermocouple Input Signal Conditioning ModuleAPPLICATIONS Industrial signal conditioning Figure 1. 7B37 Functional Block Diagram Industrial sig ..
7B37-J-13-2 ,Isolated Thermocouple Input Signal Conditioning Moduleapplications protection. The power supplies necessary to drive each of the including process contro ..
74LS48-SN54LS48J-SN74LS48N
BCD-to-Seven-Segment Decoder Driver(Internal Pull-up outputs)
BCD TO 7-SEGMENT
DECODERThe SN54/74LS48 is a BCD to 7-Segment Decoder consisting of NAND
gates, input buffers and seven AND-OR-INVERT gates. Seven NAND gates
and one driver are connected in pairs to make BCD data and its complement
available to the seven decoding AND-OR-INVERT gates. The remaining
NAND gate and three input buffers provide lamp test, blanking input/ripple-
blanking input for the LS48.
The circuit accepts 4-bit binary-coded-decimal (BCD) and, depending on
the state of the auxiliary inputs, decodes this data to drive other components.
The relative positive logic output levels, as well as conditions required at the
auxiliary inputs, are shown in the truth tables.
The LS48 circuit incorporates automatic leading and/or trailing edge
zero-blanking control (RBI and RBO). Lamp Test (LT) may be activated any
time when the BI/RBO node is HIGH. Both devices contain an overriding
blanking input (BI) which can be used to control the lamp intensity by varying
the frequency and duty cycle of the BI input signal or to inhibit the outputs. Lamp Intensity Modulation Capability (BI/RBO) Internal Pull-Ups Eliminate Need for External Resistors Input Clamp Diodes Eliminate High-Speed Termination Effects
VCC g a b c d e C LT BI/RBO RBI D A GND
CONNECTION DIAGRAM DIP (TOP VIEW)
LOGIC DIAGRAMINPUT
BLANKING INPUT OR
RIPPLE-BLANKING
OUTPUT
RIPPLE-BLANKING
INPUT
OUTPUT
